- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
well, the first thing is to check the fuses and or relay for power windows.should be listed in your owners manual. if ok, then remove switch from drivers side window and check for power. if power to the switch then use a jumper wire from power side to motor side of switch. if window works then its the switch causing the problem. Good-day!
You remove the door panel on the inside and it is bolted on from the inside. One wire clip and 3 bolts. Takes longer to remove and replace the door panel than replace the mirror....look for a hidden screw under the armrest , under the window/door lock button panel and sometimes behind the reflector or light on the bottom of door..Usually there are 3-4 screws and then the rest of the panel is held on by plastic clips. Get the screws out, then work a flat screwdriver or putty knife around the sides and bottom of panel, then lift upwards to get the top sealing side out of the track where the window runs.....Mike
Muth makes the signal mirrors for repalcing the glass in the mirror head. On the site, they have nice instructions you can use for removing the door panel, and getting the mirror off ( obviously stop at the removing the glass part, and just replace with the mirror head you already have ).
Enter the Make, MY, and model you have, and on the products page are the links to the PDF version of the instructions for download.
Remove the screws in the arm rest pocket. Remove the screw up by the mirror. If it's a power door, gently pop the master window and door lock switch from the top careful not to break the tabs. Remove the screws along the bottom. Gently pry the outer edges to release hidden plastic clips. Once it comes loose, lift to release the upper edge.
You will have to remove the door panel, behind the triangle piece on the top right of the drivers side door panel you will see 3 nuts which hold the mirror in place. Remove the nuts and the mirror should come right off the door. Same on the passenger side.
Remove the sail panel,the little panel on inside of door at the mirror.
Remove the window regulator switch plate, pry up on the front of it with a small pick or screw driver. Disconnect the electrical connectors.
Remove the top door trim panel screw that is behind the sail panel you removed.
Remove door trim panel screw at window regulator switch plate opening.
Remove door trim panel screw in the courtesy lamp housing. Remove the courtesy lamp lens.Remove the screw.
Remove the inside door handle trim cover.
Remove the bolt.
Remove the inside door handle.
Lift upward to remove the front door trim panel.
Remove the courtesy lamp.
Turn the courtesy lamp bulb socket one quarter turn and remove.
Disconnect the power mirror electrical connector.
Remove the three outside rear view mirror nuts.
Remove the mirror.
Both above answers are not right... I just replaced the Pass side power mirror assembly on my 97 Expedition. No heat, no directional. The inside door panel must come off. 1. pry off interior triangular plastic trim piece inside of door at mirror area. Remove door panel screw at this area. 2. Pry off power window switch panel and remove door panel screw at this area. 3.Remove interior door light cover and remove screw at this area. 4. Remove plastic cover at door handle. 5. The interior door panel can now be lifted up to release it from it's fasteners. 6. Disconnect light and push power window switch assembly through the door panel and it can be set aside. 7. Disconnect mirror power at coupler. 8 Loosen three mirror mounting screws with 7/16 socket. DO NOT unscrew completely.. the will fall down the door cavity. Use a round magnet on holder to remove the screws completely. 9.Thread electrical connection into door panel and install mirror. 10. Smile when mirror works and drink a beer! rayman