Question about 1996 GMC Yukon

1 Answer

1996 gmc yukon transmission fluid level and color fine, reverse out, no engine light on, hard shift at 30mph, happen suddenly no warning

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 224 Answers

Internal damage replace transmission or rebuild

Posted on Jul 31, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What happened? My Car will not drive forward or reverse, front wheels are now locked, can't even push it.


This is a transmission related issue. If the vehicle starts but will not go in any gear you have an intrernal tranny problem. Will it move at all in neutral? Check and see if the trans fluid is at the proper level. I believe these transmissions are just drain and fill ( no filter change ) during fluid service. If the fluid level is correct and a good color, the internal differential may have come apart causing the lock up situation. If the fluid level is low ( suspect a leak especially after a service ) and low fluid will cause a no shift/drive issue

Jun 21, 2015 | 2006 Kia Sedona 2.9

1 Answer

2004 yukon xl


Both are possible but from your description it sounds like the truck is in limp home mode. You need to put a scanner on it and see if any codes are set. Then repair the code and reset it then see what happens.

May 28, 2017 | 2010 GMC Yukon XL

1 Answer

2001 Audi A4 Quattro, Reverse slips


Servo or band worn out, o.ring gone hard or clutch pack burnt out.

May 14, 2017 | Cars & Trucks

1 Answer

1996 honda accord wont shift into overdrive


For Automatic transmission problem,click the link below:----Overdrive light in the dash blinks? http://repairhelpcenter.blogspot.com/2012/01/overdrive-light-in-dash-blinks.html
--------- Automatic transmission troubleshooting:----

http://howtobyme.blogspot.com/2011/11/automatic-transmission-will-not-go-into.html

---------
Automatic transmission shift lever issues?-------

http://technoanswers.blogspot.com/2012/01/automatic-transmission-shift-lever-hard.html

-----------
AUTOMATIC TRANSMISSION FLUID LEVEL? --

http://schematicsdiagram.blogspot.com/2011/07/how-to-check-automatic-transmission.html

--------------

AUTOMATIC TRANSMISSION FLUID AND FILTER?

http://schematicsdiagram.blogspot.com/2011/07/how-to-change-automatic-transmission.html

-----------
Transmission fault light on car dash?

http://schematicsdiagram.blogspot.com/2011/12/transmission-fault-light-on-car-dash.html

--------
Transmission shifting problem?

http://schematicsdiagram.blogspot.com/2012/01/transmission-shifting-problem-on-toyota.html

--------
Transmission Slips out of 2nd gear?

http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

-----------
OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

----------
Why Transmission fluid leaks near radiator?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

----------
Transmission fluid leaking?

http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-------------
****** wont go in reverse?

http://technoanswers.blogspot.in/2012/02/dodge-neon-wont-go-in-reverse.html

-------------
Automatic transmission will not go into reverse?

http://technoanswers.blogspot.in/2012/02/dodge-automatic-transmission-will-not.html

----------
Transmission is making buzzing noise?

http://technoanswers.blogspot.in/2012/02/transmission-is-making-buzzing-noise.html

-----------

This will help.

Thanks.

Mar 04, 2012 | 1996 Honda Accord

2 Answers

Transmission promblem


Assuming you have an automatic transmission, I would check the transmission fluid level. If low, you need to identify where the fluid is leaking. Probable locations are transmission pan, or the cooler lines to the radiator.
If this has only begun to happen your transmission will probably be ok. If it has been happening for a while then you will probably be looking for a new transmission.
There is also one other possibility. If the check engine light is on and the codes read something in the area of "transmission control solenoid" or "shift solenoid" then you will need to have those replaced.

Mar 11, 2010 | 1996 Chevrolet K1500

1 Answer

1996 GMC Surburban 1500 2wheel drive. Transmission shifts hard, turn engine off, crank engine and drive off ok. After a while it starts shifting hard again.


what RPM's is it shifting at?If it seems to be shifting a lot more then usual it could be a torque converter problem(locking and unlocking),for now I would try having the tranny serviced and see if the shop can adjust the shift points,also check the tranny fluid for color,amount,and smell.It should be a pinkish to red color and not smell burnt,as far as checking the fliud level run it around until the vehicle is up to running temp and follow the instructions on the dip stick for proper procedure.good luck.

Dec 28, 2009 | 1994 GMC Suburban

1 Answer

No reverse and shifts hard if forward gears


best bet is call scrap yard they are fairly decent priced unless you want new

Aug 25, 2009 | 1996 GMC Jimmy

1 Answer

96 Yukon Transmission


Check the transmission fluid level and condition of the fluid. It should be bright red like Strawberry colour. If it's dark like burgundy, then the fluid is burnt and the transmission needs to be serviced. Fluid and filter changed.
Have the Truck's computer scanned for any DTC codes. Most parts store like Auto Zone or Parts Source will scan for free. If there is a engine management Issues, it may be running your Yukon on a limp mode.
Limp mode will not let the transmission shift past 3rd gear and the OD does not engage, i had a cracked ignition cap and the computer put me on a limp mode once. 
Good luck and hope this helps. Keep me posted to please.

Mar 16, 2009 | 1996 GMC Yukon

1 Answer

Transmission


Check the level of the transmission fluid, low fluid can prevent the transmission from shifting.

Sep 08, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
1996 GMC Yukon Logo

Related Topics:

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...