Question about 1995 Ford Taurus

1 Answer

My car will start fine but when i put it in gear

My car will start fine but when i put it in gear it tries to stall if i give it gas it tries to die i can feather the pedal and get it up to speed but the least over it stalls but will start back na trouble codes are found when doing self test it also acts governed to a low rpm bacause in park it will only rev to a lower than average rpm before cutting out and back

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 64 Answers

I would check fuel pressure, it sounds like your pump is not creating enough pressure,.

Posted on Jul 31, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car will start but put it in gear engine will die


engine starts with no problem; but, when I put in gear and ...

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusNov 15, 2012 - The engine just fall dead when you step on the gas; it seems to jerk before ... My car does the same thing but i put it in neutral n it starts up. ... I have a 2004 kia optima it jerks when I go into reverse it was driving ... start and run fine butwhen I put it in drive or any other gear it dies! ... 2002 Hyundai Elantra GT.

Engine stalls when tranny put in Drive or Reverse - Kia Forum

www.kia-forums.com/kia-carnival...2002.../43407-engine-stalls-when-tr...

Feb 28, 2008 - 10 posts - ‎3 authors
Give it a little gas before putting in D or R and it will go. .... When I start the van cold and shift the tranny into drive or reverse.....the whole front ... won't run in forward gears - Kia Forum
10 posts
May 25, 2012
Intriguing problem - engine rough idle & hesitation ...
10 posts
Aug 31, 2011
2006 Kia Spectra engine stalls and bad idle, cleaning the ...
10 posts
Aug 30, 2010
2002 Kia Spectra Won't Go Out of Park - Kia Forum
3 posts
Oct 28, 2008
More results from www.kia-forums.com

Dec 17, 2015 | 2002 Kia Rio

1 Answer

1992 olds cutlass supreme wont accelerate when pushing the gas pedal


Check oil first, Low oil sensor will shut down if more than a quart low. Change fuel filter, could be fuel starvation, change the air filter. stopped up air filter will put MAF sensor out of range. PERFORM OBDII SCAN SOON.

May 19, 2017 | 1992 Oldsmobile Cutlass Supreme

2 Answers

Car will start but when put in gear it dies/stalls


my ford winstar vav stalls when you put it in drive will idol all day just find

Apr 08, 2013 | 1993 Buick Century

1 Answer

I have a chevy s10 2.2 2003 truck and one day it ran about five miles. then stalled. it started back up idled fine but put it in gear. stalled again. had to get towed home replaced the fuel filter,truck...


When you press on the gas when the truck is running, does it rev up?

Did it die while driving down the road (foot on the accelerator) or when idle? - If so, try cranking it and get your RPMs up to 1500-2000 RPMs and put it in drive (with your other foot on the brake). See if it will continue running if you never take your foot off the gas.

Apr 06, 2013 | Cars & Trucks

1 Answer

1996 mercedes c280 dies when put in drive


Engine stalls or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Oct 15, 2012 | 1996 Mercedes-Benz C-Class

1 Answer

THE TRUCK STARTS UP FINE, BUT DIES WHEN IT IS PUT INTO GEAR


if it dies when put in gear, try giving it gas while holding the brake, them putting it in gear if it does not die then replace the idle control valve iac it located on top on the throttle body

Dec 20, 2010 | 1996 Ford Explorer

Not finding what you are looking for?
1995 Ford Taurus Logo

Related Topics:

259 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...