Question about 1995 Chevrolet C1500

1 Answer

1995 Chevy C1500 2WD Pickup. It started a couple of days ago but it ran very rough and bacfired when I tried to give it some gas then it shut off and now will not start. I changed the fuel filter and when I trun the iginition on you can hear the fuel pump running. I also checked all the fuses and replaced the fuel pump relay, Iginition coil, Ignition module, distributor cap, rotor, throttle position sensor, intake air control valve and installed new spark plugs. Any suggestions as to the problem.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 6,784 Answers

HI, this seems to be a timing issue you belt or chain has jumped timing. i would also advise to check the integrity of the crank and cam shaft position sensors as well. this will shift the ignition timing sightly if either one or both sensors are faulty or misaligned.

The ignition timing is regulated by the pcm so, if the sensors(crk/cam) are defective, this will be the issue.

Now, if the sensors are ok, this will confirm a jumped timing issue with the chain or belt.

Posted on Jul 30, 2009

  • Michael Masters
    Michael Masters Jul 30, 2009

    The camshaft position sensor is located Under hood, center, rear engine area, mounted inside





    distributor, and the Crank shaft sensor is located








    Under hood, center, front engine area, rear of





    crankshaft pulley, mounted in engine block.










×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1999 chevy silverado starts and dies within two seconds. has anyone had this experience before and how did you fix it?


does it have a b2960 security code set, i bet it does, it probably has a security problem and is going into fuel shut off, try replacing the ignition switch harness, this is 98% of the time the problem

Jan 15, 2013 | 1999 Chevrolet Silverado 1500

1 Answer

Have a 2005 f350 6.0 diesel past two days idle jumped a couple times then had hard starting a few times cranked but no start then finally started ran rough tried stepping on gas lever and nothing happened...


I have the same problem few days ago and found my solution on Fixya Expert Sources website. Here you will get all the top sources of your problem. All the sources of this site provided by top Fixya Gurus. Have a good look at the sources of the page. Go through the sources to find your solution. Hope it will help.


View Count:4

Aug 11, 2011 | 2005 Ford F 350 Super Duty

2 Answers

1998 chevy s10 driving along and engine shut down.after sitting 10 min.it started but was rough.went 100.ft and it shut off again.sat for a while.it started and ran a couple miles like nothing was ever...


if it shuts off while driving and will not start back up for at least 10 minutes, then it may be the crank sensor doing this. is check engine light on! if so get it scanned to find problem code. if no scanner, auto-zone will scan for free. if light is on. CPS symtoms are: car dies and won't re-start till it cools down, or won't start at all. good-day ! crank sensor timing will be out of sync. it controls timing and sends info to pcm.

Jul 19, 2011 | 1998 Chevrolet S-10 Pickup

1 Answer

1995 chevy g 20 va 5.7 engine runs rough even


You may have picked up some debris and/or water when it ran out of gas. That got sucked up into the filter. Try changing the fuel filter I believe it's located on the right side, just ahead of the rear wheel.
Try that and see if there's any improvment. Hope this helps.
Good luck.

Jan 20, 2010 | 1995 Chevrolet G20

1 Answer

My question is this I have a 1983 toyota pickup truck with the 22R engine.About a week ago I pulled out ot my drive way and when the motor warm up it started to run rough and black soot was coming from my...


black soot is a running rich condition it's getting to much gas not enough air .. 14-1 ratio air to gas your carb rebuild needs to be rechecked for sticking float..

Nov 19, 2009 | 1983 Toyota Pickup

Not finding what you are looking for?
1995 Chevrolet C1500 Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8201 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...