Question about 1996 Chevrolet Blazer

1 Answer

Starter wires diamgrram - 1996 Chevrolet Blazer

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 355 Answers

Starter And Charging (Part 1 Of 2) starter wires - 58940447

Posted on Aug 06, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I jump the starter on my 91 camaro?


hot wire starter you can short out ignition switch and wiring. to jump starter ignition switch start postion.you have to run 10 gauge jumper wire from the starter solenoid positive battery terminal to starter switch or S terminal on starter solenoid this procedure take two people but better remove starter replace starter solenoid. trying jumping off starter on camaro would be dangerous you have jack up car to get to starter and wiring person laying under car hot wiring starter while other person hold ignition start position put person under car in deadly position just remove starter have auto parts check it out first replace starter or solenoid if either bad. easier hot wire starter if starter under hood like my 1977 vega monza had starter at top could take long screw driver jump starter off.on the four cylinders engines back in the 70s. camaro starter under car dangerous trying to hot wire not a good idea.

May 07, 2013 | Cars & Trucks

1 Answer

How to replace a starter on toyota corolla 1999


Make sure you have your radio code if needed otherwise the radio won't work after this. Disconect battry, Unbolt main wire from starter, disconect switch wire from starter, unbolt starter, remove starter, fit new starter, connect switch wire, connect main wire to starter, connect battrey, start a couple of times to make sure all ok, input radio code.

Jun 24, 2012 | 1999 Toyota Corolla

1 Answer

Putting starter back on vechicle need help with wiring


LOOKING AT STARTER WIRES.BATTERY CABLE POSITIVE CABLE GOES TO STARTER SOLENOID POSITIVE POST TERMINAL THAT IS THE LARGE STUD IN THE STARTER SOLENOID.. THE OTHER TWO RED WIRES WITH LARGE RING TERMINALS ALSO GOES TO THE STARTER SOLENOID POSITIVE POST TERMINAL.THE PURPLE WIRE WITH SMALL RING TERMINAL GOES TO S OR SWITCH POST TERMINAL.ON STARTER SOLENOID LOOK AT THE STARTER SOLENOID YOU WILL SEE LETTERS R AND S ON SOLENOID THE PURPLE WIRES WITH SMALL RING TERMINAL GOES TO S STUD TERMINAL ON STARTER SOLENOID.

May 26, 2011 | 1999 Oldsmobile Alero

2 Answers

STARTER WON'T STOP


If its a new starter check and see that the wires are hooked up right, could be time for a new starter, or starter relay on the fender well, or the ignition switch is bad.

Jan 20, 2011 | 1988 Ford F 250

1 Answer

Need to know how many wires go to starter


STARTER HAS 3 WIRES BIG HEAVY RED CABLE IS THE POSITIVE BATTERY CABLE TO STARTER SOLENOID.THE SMALL RED 10 GAUGE WIRE ON STARTER SOLENOID ASLO IS THE FUSE LINK WIRE TO STARTER AND ALTERNATOR.SMALL 10 PURPLE WIRE GOES TO STARTER SOLENOID S TERMINAL MEANING SWITCH.

Sep 28, 2010 | 1999 Chevrolet Cavalier

1 Answer

How do you remove the wires from the solenoid of a 1995 S-10 chey with a 4.3L w engine? How is the starter removed really.


remove batter cable from batter. follow postive wire down to starter. Should be some "clips" holding wire into place on the waay down to starter. Loosen those clips and take the wire out. Remove wires from stater. Remove two starter bolts. Job is done. By removing the wires out of those clips you give yourself enough slack to easily do this job. If there still isn't enough room for you, it's not suggested but occsaionaly done, once those wires are removed from the clips, remove starter bolts, the starter will hang by the wires while you remove the wires. This can damage the wires and maybe the solenoid on the new starter. That's why it's NOT SUGGESTED.

Jul 21, 2010 | 1996 Chevrolet S-10 Pickup

1 Answer

My starter won't stop starting, and my key doesnt stop it


Check the wires at the starter, and inspect the wires at the starter solenoid for any damage or missing wire insulation allowing the wires to make contact with each other or ground, and check the wire to the "S" terminal on the starter solenoid to be sure that it is not touching the main battery cable at the "Bat" or main terminal on the starter solenoid.

If there is no problem with the wires to the starter solenoid, especially the wire to the "S" terminal on the starter solenoid, and there is no after-market alarm installed with a starter enable, then the problem will be with the ignition switch.

Jul 02, 2010 | 1983 Jeep CJ7

1 Answer

How do you remove a 1999 Nissan Altima starter?


Nissan Car Altima & Sentra 1999-06 StarterRemoval & Installation
  1. Remove or disconnect the following:
    Negative battery cable Air duct Harness protector from the harness Starter wiring at the starter Starter-to-engine bolts Starter from the vehicle


  2. b53bb6c.jpg
    Fig. Starter location and mounting detail-3.0L Maxima with a manual transaxle


    b2eb267.jpg
    Fig. Starter location and mounting detail-3.5L Maxima

To install:
  1. Install or connect the following:
    Starter and torque the long bolt to 57-72 ft. lbs. (77-98 Nm) on Altima and Maxima and 41 ft. lbs. (55 Nm) on 350 Z. torque the short bolt to 22-30 ft. lbs. (30-41 Nm) Starter wiring Harness protector Air duct Negative battery cable
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter

To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

1.6L & 2.0L Engines
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negaative battery cable

1.6L, 1.8L & 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negative battery cable

1.8L & 2.0L Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    Negative battery cable Wiring at the starter Bolts attaching the starter to the engine Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 70 inch lbs. (8 Nm) Starter electrical connections Negative battery cable

2.4L & 2.5L Engines
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

2.4L Engine
  1. Remove or disconnect the following:
    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

2.5L Engine
  1. Remove or disconnect the following:
    Negative battery cable Air cleaner cover and duct Harness bracket Wiring at the starter Starter
To install:
  1. Install or connect the following:
    Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable

3.5L Engines
  1. Remove or disconnect the following:
    Negative battery cable Air cleaner case (upper) and air cleaner to electric throttle control actuator tube. Harness protector from the harness Starter wiring at the starter Starter-to-engine bolts Starter from the vehicle

    42c548c.jpg
    Fig. Starter location and mounting detail-3.5L engine

continue...

Apr 05, 2010 | 1999 Nissan Altima

1 Answer

Starter replacement on 1997 dodge intrepid


Disconnect battery negative cable Remove and Install Battery Cable
Raise vehicle.
For easier servicing, do not remove the wiring from starter at this time.
Remove three starter attaching bolts from engine/transaxle Starter -
Remove starter assembly from transmission housing. Position the starter to gain access to the wiring connectors.
Remove the battery positive cable nut from starter and remove the cable Wire Terminal Connections .
Remove the starter from vehicle.
INSTALLATION
For installation, reverse the above procedures. Clean corrosion/dirt from the cable and wire terminals before installing wiring to the solenoid.Thank you for using FixYa,Lee Davidian

Jan 11, 2010 | 1997 Dodge Intrepid

Not finding what you are looking for?
1996 Chevrolet Blazer Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...