SOURCE: I am rebuilding 3cyl diesel
you will need a manual for this as diesel torque settings are different to that of a petrol engine.
SOURCE: 88 daihatsu charade idling problems
You need to check the throttle stop cushion is making contact. The engine will hunt if you have air in the throttlebody coolant pipes, if the coolant sensor is faulty or if the TPS isn't calibrated.
SOURCE: engine
how do i replace the valve cover gasket on a 1991 daihatsu charade .i beleive its a c-9 motor
SOURCE: Need to change a WATER PUMP on my DAIHATSU CHARADE GLXI 1994
The location of the pump is on the left hand side of the engine when standing at the front of the car.
You will see (if you have aircon) two belts.
If you stand to the side of the car to look at the belts.
From memory the inner one (closest to the engine) drives the aircon compressor.
The outer one drives the water pump, you will see the pump belt wheel towards the back of the engine.
Getting into the pump is a bit tricky.
I basically unbolted the engine mount from the body which then allowed me to jack up the engine as I needed it to give me space to unbolt everything until the 3 water pump bolts can be seen.
Just make sure you know which bolts go back where.
From memory there were about 20 bolts to undo before I got to the water pump.
Aircon compressor bracket bolt I only loosened them from the engine not fully removed, the same with the alternator I only removed the adjusting bolt to remove the belt.
Oh I just thought of something to do before you remove the tension on the belts... loosen slightly the 4 small bolts that are on the wheel that bolts onto the water pump.
I think the only size sockets and spanners I used were 10, 12, 14 & 17.
It took me around 2 hours to get it all undone, and close to the same to put it all back together with the new pump.
It was kinda straight forward as you can see what you need to unbolt because you know what bit you need to get into.
I hope this helps a little, I am not sure if it is clear in the way I have written it. But feel free to ask any questions.
SOURCE: what should the valve timing be on a 1990 daihatsu charade 1990 3 cylinder
Ignition timing should be checked and adjusted whenever spark plugs are replaced or any distributor maintenance is performed. Ignition timing at 1000 RPM or less should be as follows: on 1989 1.3L/4-79 engines, 3-7°BTDC; on 1990-92 1.3L/4-79 engines, 0-2°; on 1.6L/4-97 engines, 1-5°.
39 views
Usually answered in minutes!
×