When I start the truck nothing comes on on the heater display or blower
Look at the fuse panel. There will be more than one fuse panel. Inside the passenger compartment AND inside the engine compartment. I do not know Fords that well, but you want to look for a Fuse marked HEATER or BLOWER.
If that fuse is blown, replace it with one the same size. If it blows again, you have a bad blower motor, a bad resistor or a bad switch.
disconnect the motor, replace the fuse and try it again. If the fuse survives, replace the motor.
SOURCE: 2000 ford expedition eddie bower suspension
If you change the standing height of your 2008 silverado this could void your warranty.Please check with your local chevy dealers service dept.Best of luck.
SOURCE: 1990 geo Prizm fuse location for the heater blower
the heater blower motor is run through two fuses. the gauge fuse in fuse block 1 and the ac fuse in fuse block 4.
SOURCE: blower motor 1995 ford explorer
if ur blower only came on the high fan speed i say it was ur blower resistor , but ur blower aint working at all so i would replace the blowerand the resistor cause they eventualy good out with when then the blower problems
SOURCE: Airbag light flashes then stays on in our 2002 Ford Explorer.
Safety Belt pre-tensioner Status (Driver pre-tensioner Circuit Fault).
On the seat belt buckle there is a pre-tensioner that when vehicle is involved in an accident it will deploy and pull the belt tighter.
If the vehicle has never been involved in an accident it could be what we call terminal fretting which is just a build up on the terminals which cause a open circuit. Usually just unplugging and reconnecting the connector a couple of times will fix this.
If this doesn't correct it I would recommend having your local dealer look at it.
50 views
Usually answered in minutes!
×