Question about Cars & Trucks
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
its in series in the exhaust system, but check you have particulate fluid in the vehicle first before replacing the filter
Posted on Jun 24, 2010
best advice i can give is to make a coca can gasket for the ERG valve so it blocks the hole off ,then it will run ok promise ,you do not this device and it will pass the mot without it ,nobody will even know its blocked off
Posted on Dec 26, 2010
Those are multiple problems. ABS is antilock brake system. Normally this comes on when you need to replace your brakes. Also replace the engine oil in your car and have your car tuned. The check engine light will more than likely go off. If not then the mechanic will tell you what needs to be done to make it go off. Hope this helps
Posted on Jan 18, 2011
We had this with our grand picasso all the warning lights on then car went into limp mode replaced two lambda sensor as this is what citroen thought it was in the end coolant sensor was leaking up wire back to ecu making all kinds of lights come on as it malfunctioned in the end new ecu cost over thousand pounds.
Posted on Aug 29, 2012
Anti pollution light, I never heard of a Check engine light being called that.
Read on please.
When the service engine soon light (Also called the check engine light or engine management light) is turned on this is to alert you to the fact that Powertrain Control Module (computer) has detected a failure somewhere in the systems it controls you may not feel any difference in the way the engine runs, this can be the transmission or the engine or emission system, there are fault codes set in the modules memory for these faults. What needs to happen now is to have the powertrain control module scanned with a special tool called an OBD2 electronic engine control scanner or a OBD2 code reader. Once the code(s) are read then you must perform the diagnostics for each code and make the appropriate repairs based on the findings of the diagnosis that was performed, this is called doing "Pinpoint" testing.
Posted on Nov 04, 2012
Tips for a great answer:
Dec 19, 2017 | Peugeot 207 Cars & Trucks
Aug 02, 2016 | Peugeot Cars & Trucks
Sep 13, 2015 | 2007 Peugeot 207 1.4
Apr 04, 2015 | 2007 Peugeot 207 1.4
Aug 30, 2014 | Cars & Trucks
Apr 26, 2014 | 2006 Peugeot 207 1.4
Jan 11, 2013 | Cars & Trucks
Jul 01, 2012 | 2008 Citroen C-Crosser HDi
Mar 16, 2012 | 2007 Peugeot 207 CC
Jan 20, 2018 | Audi Cars & Trucks
19 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: