My 2013 ford escape SUV is faulty and the part with code P26B7 is said to be faulty and need replacement any I don't know where to get it to buy in this world. pls help
Coolant bypass solonoid fault ps not hard to do good luck under the bonnet
Testimonial: "pls Mr Evans I need to replace the part not to repair it and I want to know where I can get it to buy I.e the p26b7 pls"
SOURCE: wheel bearing
u have to take the hub off. and press the wheel bearing out. it takes alittle time to do bc u have to take your rotor and brake assembly off to get to the hub.
SOURCE: 2005 Escape starter replacement
take the negative side off the battery put the car on ramps secure the rear end so it does not roll and if you need a diagram for removing and installing the starter try autozone
SOURCE: 2005 ford escape assembly diagram for the front axle
If they are sealed bearings, you will need a press to get them out. If they are bolt in, just remove the brake pads/rotors, then the axle nut, then the bolts holding the wheel bearing in. Install in reverse order.
SOURCE: Need to replace headlight assembly on 2005 Ford Escape
ithere are 4 bolts that hold it in...the top 2 are obvious..the others are behind the bumper. the bumper must be removed to acces them...here are the manuals instructions..
Item
Part Number
Description
1
—
Headlamp assembly bolts (3 required)
2
—
Headlamp assembly nut
3
13008
Headlamp assembly
4
14290
Electrical connectors
Removal and Installation
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.
SOURCE: ford escape 2002 firing order
V6 1-4-2-5-3-6 back bank pasenger side right to left cylinders 1 2 3
front bank passenger side right to left 4-5-6
4 cly 1-3-4-2
157 views
Usually answered in minutes!
×