Question about 1995 Oldsmobile Aurora
Go to the autozone website at autozone.com and register your vehicle. It's free and you will have access to an online repair manual for your vehicle. The procedures you want are there. ( I checked) Hope this helped and best wishes.
Posted on Jul 30, 2009
Click on this link for basic diagram: http://www.autozone.com/autozone/catalog/parts/jobDiagram.jsp?engineCyl=8&ymmeId=2001/37/35/515&imageURL=&categoryDisplayName=Cooling+%26+Heating&productType=00&parentId=172 First thing is to drain your radiator of all coolant by opening pipcock at base of radiator (catch the old coolant in a pan but I myself would not reuse it.) As you can see in the diagram, you'll need to remove upper and lower radiator hoses and overflo hose. (Remove all hoses at the radiator only...no need to remove completely.) If applicable, unattach transmission cooling lines from the radiator. (If desired, you can temporarily plug ends of tranny lines with clean pieces of rag.) Last, there are two radiator hold down clamps which are easy to get at and remove, as you can see in the diagram. After removing these you should be able to lift the old radiator straight up and out. Hopefully you will not need to remove your cooling fans. Carefully reverse the process with your new radiator, refill the system and you're done. How "cool" is that??? Hope I helped
Posted on Jul 30, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
i found it best to remove radiator first before trying to tackle the alternator... once that is removed then you can easily get to it to unloosen bolt and swap
Posted on Mar 23, 2009
take the brake caliper and caliper hanger off and the rotor should just pull off if the rotor is on real tight using a hammer to hit it off with is a good ideal
Posted on Jan 06, 2010
Testimonial: "this was just what i needed. there were a couple of washer clips holding the rotor snug and coaxing it with a hammer did the trick. Thanks!!!"
Could be a head gasket, check compression on all cylinders, Check oil level and see if the dipstick has any moisture on it. Check the radiator coolant for exhaust oder or crankcase oil.Also make sure there is not old gasoline in the tank in the event the vehicle has been stored for a length of time.
Posted on Jul 24, 2010
most oil filters are screw off /screw on type ,you may need a oil filter remover tool to get them off when you replace them be sure to smear a light coat of oil on to the rubber ring on the filter to prevent damaging it ....hope this helps.....cheers
Posted on Jul 28, 2010
Tips for a great answer:
Dec 25, 2014 | 2001 Oldsmobile Aurora
Jun 26, 2014 | 2001 Oldsmobile Aurora
Dec 25, 2011 | 2001 Oldsmobile Aurora
Nov 01, 2011 | 2001 Oldsmobile Aurora
Aug 21, 2011 | 2001 Oldsmobile Aurora
May 04, 2011 | 2001 Oldsmobile Aurora
Jul 24, 2010 | 2001 Oldsmobile Aurora
Nov 14, 2009 | 2001 Oldsmobile Aurora
Mar 01, 2009 | 1995 Oldsmobile Aurora
609 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: