Question about 2004 Honda CR-V

1 Answer

Hook up light harness for 2004 honda crv

I have a 2004 Honda crv to which I had a hitch installed. Now I want to put a light harness on it for a trailer I want to pull. I have the light kit harness, but can´t find the place to plug it into. Thoughts_

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 65 Answers

Advance and other auto parts sell a Hobie brand kit that simply plugs into the tailamp circuit. Follow directions supplied and you have trailer lights

Posted on Nov 01, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Eng runs then dies after a few seconds on honda crv 2004 since changing crankshaft pulley seal


Make sure the crankshaft sensor and harness weren't damaged during installation. Check to see if you have a check engine light. If so put a scanner on it and see what fault(s) are present.

Nov 25, 2015 | Honda Cars & Trucks

1 Answer

Change battery on my 2004 honda CRV 2wd i need a code to reset radio


The code is usually on a sticker on the side of your radio or the side of the glove box. sOME TIMES THEY WILL PUT ONE OF THE STICKERS IN YOUR OWNERS MANUAL ALSO
Good Luck

Apr 10, 2012 | 2004 Honda CR-V

1 Answer

How do you hook up trailer lights so i can pull a trailer


If you bought the Honda hitch kit, a wiring harness and instructions are included. If you bought a different kit, buy the wiring harness from Honda. The harness connects to a plug located in one of the accesses panels in the back. You will have to take off the. Bumper facia to route the harness to the hitch. Be sure to use the rubber grommets to prevent the sheet metal of the rear quarter panel from wearing through the wire insulation and causing a blown fuse.

Aug 07, 2011 | 1997 Honda Passport

2 Answers

Honda 2004 CRV "D" light


There are a lot of lights please be more clear on which light is flashing. If it is the service engine soon light you will have to run a diagnostic test on it.

Jan 04, 2011 | 2004 Honda CR-V

1 Answer

Where do i feed the wires through to wire up the towbar on a 1997 honda crv?


If you have a wired tow hitch on your car you will need to mate this to the wiring harness on the tow bar. If the two wired units do not match then you will either need an adapter or will need to rewire the tow dolly or the car. If the car doesn't have a tow light unit installed you will need to install one that will mate to the tow bar light unit.

I hope this helps - please rate me

Mar 18, 2010 | 1997 Honda CR-V

1 Answer

Honda crv 2004 brake lights night lights


LOOK FOR BRAKE LIGHT FUSE OR BURNED OUT BULBS BAD BULB SOCKETS OR GROUNDING PROBLEM.

Feb 24, 2010 | 2004 Honda CR-V

1 Answer

2004 Honda CRV - Front Brakes running hot!!!


either caliper seized ? also when you installed the rotors did you have them machined ?

Oct 19, 2009 | 2000 Honda CR-V

2 Answers

D light flashing on dash 2004 honda crv


this is a common problem in honda's. the best way to fix is to disconnect the neg battery terminal and wait 5-10 min and put it back on this will reset the ecu and should fix the problem.

Sep 29, 2009 | 2004 Honda CR-V

1 Answer

2004 Honda CRV tail lamp assembly


remove the grommet the wires go through, you may be able to reach the connector or remove inner trim panel.can you not use the original loom and just change the light unit?

Dec 29, 2008 | 2004 Honda CR-V

Not finding what you are looking for?
2004 Honda CR-V Logo

Related Topics:

255 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...