Question about Cars & Trucks

2 Answers

My 1994 crown vic lx is accelerates by itself

It runs good for about 2omins or so and starts acting up

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 1,389 Answers

Most auto part store offer a free diagnostic scan and can help narrow down the reason.

Posted on Dec 02, 2017

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 5,330 Answers

The idle air control circuit may be sticking wide open .

Posted on Dec 02, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

emissionwiz
  • 85020 Answers

SOURCE: 1996 Crown Vic, Valve noise under heavy acceleration

No use what's in there, but have the engine de-carboned by a Ford dealer, or remove the octane adjust shorting bar located near the ignition module (retards timing 2 degrees), this will in most cases cure the issue unless there is allot of carbon in the cylinders. There are also methods of ing this de-carbon procedure at home, check on the internet for tips.

PLEASE RATE THIS SOLUTION

Posted on Oct 22, 2008

  • 10 Answers

SOURCE: The speedomter on my 1994 Crown Victoria has stopped working

most likely the speed cable broke.

Dave

Posted on Apr 20, 2009

  • 5692 Answers

SOURCE: 94 crown vic driver power window does not work can

The window regulator can be broke. Its made of plastic and they break often.

Posted on May 05, 2009

  • 204 Answers

SOURCE: no high beams on my 96 crown vic. fuses good. any suggestions?

look under the hood in the big fuse panel and look for High beam headlight relay the relay is more than likely bad

Posted on Jun 17, 2009

  • 76 Answers

SOURCE: cant start my crown vic 1998

ignition switch or starter relay or a wiring problem

Posted on Oct 03, 2009

Testimonial: "knows what he is talking about"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What to do when your 1994 crown vic v8 stops in rotation while driving on highway and acting like it was braking on its own?


So many possibilities here... One may be that a wheel bearing is overheating/seizing. Also is the coolent level okay? All fan belts especially to the water pump good? What you need is a good trouble shooting guide because there are just too many possibilities here and too little information. Sorry...

Aug 28, 2014 | 1994 Ford Crown Victoria

1 Answer

Hello? Emission problem 1994 crown vic here...


I owned one of these. There is a groove under the butterfly horn of the throttle. There are 8 bolts and a $10 gasket. Often the EGR passage is clogged and it throws off the calibrations and when you clean this groove the engine will run much better.

Jul 21, 2014 | 1994 Ford Crown Victoria

1 Answer

How to take rear inside door panel off 94 ford crown vic lx


michael_cass_313.jpg
Hope this helps you ?? ps. would have made picture bigger, but this web page won't allow it....

Jul 14, 2011 | 1994 Ford Crown Victoria

1 Answer

1994 ford crown vic front pass. side power window regulator...


Yes it is. They will need to be drilled out. Thats the best way, some people try to put bolts on, but I dont advise it.

May 12, 2010 | 1994 Ford Crown Victoria

2 Answers

I have a 94 crown vic that blows blueish white smoke sumtimes on acceleration but then it goes away, it doesnt do it on start up and it runs fine otherwise


If there is a blue tint you are burning oil. You may have worn rings, or you may have one ring that is stuck and letting oil by. There may also be hardened valve stem seals. As old as it is try switching to full synthetic oil after doing an engine clean. It will not burn.

Hope this helps

Apr 09, 2010 | 1994 Ford Crown Victoria

2 Answers

Crown Vic Fuel Problem? Maybe?


sounds like the trottle position sensor is acting up, if u have a scanner u can check it on live data, but it should thow a code some autoparts dealers offer free code reading

Mar 25, 2010 | 2000 Ford Crown Victoria

1 Answer

2001 Crown vic LX Sport..Blower motor inop car has auto climate control. blower stopped then worked again then stopped again.


The blower motor might be bad,turn it on,high blower,and bump the blower motor body with the palm of your hand,if it starts to run,or tries to run,then replace the blower motor.

Jan 05, 2010 | 2001 Ford Crown Victoria

1 Answer

1998 ford crown vic sputters


I would try to replace your spark plugs, and spark plug wires, My 88 Vic did the same thing...now it runs like a champ....you could also try fuel injector cleaner.

Jun 12, 2009 | 1998 Ford Crown Victoria

1 Answer

2003 Crown Vic Misfiring after acceleration


I just came up with that exact issue in my 2003 with 98K police crown vic. And the last time I had this issue in a 2001 police Crown vic it was the crank shaft position sensor. A $20 part and about 30 mins to put it in. located near the bottom of the engine. I had to un bolt the A/C compressor and push it out of the way a few inches to get to the sensor. If you have about 100K mile on it and its an idled heavy police car, this sensor should be changed out anyway. It can leave you on the road dead and some dealers have a hard time find out whats wrong as the OBD 2 does not see it as a problem when it goes bad or becomes touchy as I think mine is.

Jan 12, 2009 | 2007 Ford Crown Victoria LX Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

21120 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...