Question about 2000 Oldsmobile Silhouette

Open Question

Van stalling. now will not stay running. ran smooth for a min till i turned on the air. stutering and died again. Got worse and worse pass couple days

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Van won,t start montanasv6 did a diagnostic on it the c305 came up


Could be fuel pump or fuel relay, sound like you're not getting enough gas.

Nov 24, 2013 | 2005 Pontiac Montana SV6

1 Answer

Why does Van die when you turn the steering wheel?


Engine stall or RPM fluctuates at idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Sep 24, 2012 | 1991 GMC Safari

1 Answer

95 mercury i replaced tps and mass flow air and car running for 10 min now wont start at all


I would check for trouble codes in the computer and fuel pressure next.
You need to figure out if you are dealing with a no spark or low fuel pressure issue to proceed.

Aug 14, 2012 | Mercury Cars & Trucks

1 Answer

The car runs well until it gets hot ,it begins to loose power,then is stuter,then shut off. the car makes a coughing -like sound when it shuts off


could be your crank angle sensor to test .turn car on then let it warn up till it cuts out then tip cold water or hose for a couple of mins on the crank angle sensor then stop water and turn car on . if it buggard it will start as when the crank angle senors breaks or is on its way out it will start then idle for a bit then splutter run **** then stall with the cold water it instantly makes it cold again so it will start straight away and repeat the same process of stallin when warm

Sep 04, 2010 | 1995 Honda Civic

2 Answers

Runs fine till warms up then losses power and dies


Does the fuel line still have 55 PSI when engine warmed up? Any other codes show up?

Aug 22, 2009 | 1998 Chevrolet Blazer

1 Answer

The eng. Run Great ,no problems until the Eng. warms a bit sometimes this only takes a fesw min.then it runs rough for a few min. then it dies and wont start back. till the next day. the problem began...


ign. module needs replacement.Very common problem.Be sure that you use the dielectric grease on thenew part,also do not wipe off the old grease completly just smooth it out.

Jul 26, 2009 | 1993 Chevrolet S-10 Blazer

Not finding what you are looking for?
2000 Oldsmobile Silhouette Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...