SOURCE: Oil pressure goes to high right away as soon a car is started on
Try replacing the oil pressure sending unit
SOURCE: Audi A3 2002 model auto - temperature gauge not working
The guage and fan speeds work on independant sensors. If you can remove the plastic engine cover and locate the "sending unit" for the gauge disconnect it and restart the engine. The gauge should remain cold and not move. If this is the case replace the sending unit. This should be a single wire sender located in the waterjacket of the intake manifold look in the area where the upper rad hose enters the intake.
SOURCE: 1998 honda accord check engine light on code p0141
SECONDARY HEATED O2 SENSOR HEATER CIRCUIT FAULT SENSOR 2.
SOURCE: P242F Bank1Sensor3 sprinter fault codes 07 Sprinter 2500
Bank one is the side on a V or H engine where cylinder number one is located. On an in-line engine you only have a bank one, no bank 2. Sensor 3 will be the third sensor from the engine in the exhaust stream.
Testimonial: "That was extremely fast answer :)"
SOURCE: Citroen Xantia Temperature warning light
My friends ,especialy in a few first miles my Xantia (year 1995) has very stiff steering , most from newtral position .Thak you
1,663 views
Usually answered in minutes!
×