I don't know how to hot wire it, if possible? I looked at your security system, it said passlock. The pass lock key is just a mechanical key, no pellet or transponder in the key. It's the tumbler that communicates with passlock system, not the key. Your local dealership might get you a new key for about 20 bucks, don't quote on that. A locksmith will make you a new key, I don't know how much they charge?
SOURCE: 2005 chevrolet impala ignition swich
Even if you bypassed the switch, your steering would remain locked. In order to determine what is wrong with it, (other than the obvious) It will need to be taken apart. You will need a manual (such as Haynes, chilton etc) in order to do this safely and correctly.
SOURCE: 2005 Chevy Impala key seats in ignition but will not turn
With the key in the ignition try turning the steering wheel side to side, it may require a bit of force in either direction to get the wheel freed up and allow the key to turn. This happens when you don't allow the steering wheel to come to a resting spot before removing the key from the ignition.
SOURCE: radio unlock coed for chevy impala
• A module which communicates on the class 2 serial data circuit which supplies VIN information to the radio is replaced and not properly setup with the correct VIN information for that vehicle. The only way to unlock the radio is by using a scan tool.
SOURCE: How do i change the Blower motor resistor on a 2005 chevy impala?
The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.
SOURCE: 2005 Chevy Impala ignition switch stuck in off position
if it doesnt turn you have a worn out ignition cylinder, the only fix is to replace it, Code the ignition lock cylinder, if necessary
CAUTION:Perform the body control module (BCM) theft deterrent relearn procedure whenever you replace the ignition switch lock cylinder.
2,619 views
Usually answered in minutes!
×