I was low on gas in my 99 Acura RL and as I was driving to the gas station, the car started dragging then accelerating as if on its own. The gas light came on at the same time that the engine malfunction indicator lamp came on. I checked the gas cap and have started the car at least three times (per the manual) since then. It starts fine, but the lamp is still on. Any suggestions on what else could be going on?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Those are transmission codes. The engine light would come on with these. The other lights, They are shut down automatically with certain transmission and engine codes. Fix the transmission codes, the other lights will go off.
the best and safest way to remove this radio is with the special tools that Acura made specifically for removing the radio. Any radio store or best buy can easily remove it for you. I hope this helps please rate this and thank you.
it will be a solenoid
the code p 0740 refers to torque converter clutch (TCC) solenoid ---circuit malfunction===causes --wiring--TCC-- ECM /? TCM ( transmission control module
it is not a transmission problem so leave it alone
it is an electronic control problem so check wiring and connections and if it is either the solenoid or the TCM replace what is faulty
take it to an accredited auto transmission specialist shop have an tranny oil change done , have the bands and clutch pack s adjusted and have them check the TCC solenoid and TCM for correct operation
probably find that there will be an improvement in the fuel consumption after that
I would think ur low beams are burnt (the bulbs) because that dim light u see should be the daytime running lights, which are usually less bright that the lights turned on. Verify ur fuses as well for the low beams. Check on that for now and get back to me if u have questions.