Torque specs on 2006 cadillac dts water pump. 5 bolts

Mike Vincent

• 358 Answers
• Posted on Jun 10, 2009

SOURCE: what are specs for water pump bolts for 2001

Home | Account | Contact ALLDATA | Log Out | Help ALL TUNE & LUBE DDG AUTOMOTIVE Select Vehicle | New TSBs | Technician's Reference Component Search: Conversion Calculator 2001 Ford Taurus V6-3.0L VIN 2 Flex Fuel Vehicle Level Specifications Mechanical Specifications Water Pump Water Pump Water Pump Notes Engine Front Cover and Water Pump Assembly 25 Nm (18 lb-ft) © 2009 ALLDATA LLC. All rights reserved. Terms of Use

SOURCE: i need torque specs to change a water pump for a

dont know the specs but you should be ok if you tighten the bolts snuggly and then 1/2 turn this will usually suffice just be careful not to over tighten

SOURCE: i need bolt torque specs for a 2006 chevy cobalt

if you just go to a mecanic and ask what are the specks on that they should know but i think if you just tighten them down with an impact wrench till it is really tight after ou start the car it will run like **** then it will work its self out

SOURCE: what is the torque specs for the water pump bolts

24nm or 18 ft-lbs

ZJ Limited

• 17989 Answers
• Posted on May 01, 2010

SOURCE: i'm looking for torque specs on the water pump

Fig. Exploded view of the water pump assembly mounting-4.3L engine



To install:

1. Clean the gasket mounting surfaces.
   NOTE The water pumps on some of the engines covered may have been installed using sealer only, no gasket, at the factory. If a gasket is supplied with the replacement part, it should be used. Otherwise, a 1 / 8 in. (3mm) bead of RTV sealer should be used around the sealing surface of the pump.
   
2. Apply sealant to the water pump retainer threads.
3. Install or connect the following:
   
   Water pump using a new gasket. Tighten the water pump retainers to 89 inch lbs. (10 Nm) for 4.2L engines, or to 30 ft. lbs. (41 Nm) for 4.3L engines. For 5.3L engines, tighten the bolts to 11 ft. lbs. (15 Nm), then to 22 ft. lbs. (30 Nm). Coolant hose(s) Water pump pulley. Tighten the pulley bolts to 18 ft. lbs. (25 Nm). Fan or fan and clutch assembly Serpentine drive belt (if equipped) by positioning the belt over the pulleys and carefully allow the tensioner back into contact with the belt. V-belts (if equipped) and adjust the tension Upper fan shroud Negative battery cable
   
4. Refill the engine cooling system.
5. Run the engine and check for leaks.

Testimonial: "thank you for your time it was helpful"