Question about Dodge Ram 1500

1 Answer

Dodge Ram 1500 4x4 5.2L; fuel pump keeps blowing up. Any ideas. Replaced Crankshaft position sensor and fuel pump. Still blows the fuse.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 87 Answers

Check to make sure the fuel pump relay is not stuck in the on position.

Posted on Jul 29, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1995 dodge ram 1500, I just replaced the fuel pump, and battery cable to the starter. Now here's my question every time I turn the key to the on position tying to start it it blows the 10amp mini...


for the fuse to blow there is either to high a power draw to that particular component , is it the fuel pump fuse ? or there is a short to earth , if it is the fuel pump fuse you may have pinched a wire during the repair, if the fuse isn't for the fuel pump check the component it is for

Jun 30, 2014 | Cars & Trucks

1 Answer

2003 CRYSLER 300 SM DTC # P0481 AND # P0340 ALSO # P0300...HELP


code P0481 high speed number 2 fan relay control circuit. check for faulty fan 2 relay blowed fuse. code P0340 no camshaft position sensor circuit failure.possible causes camshaft sensor has failed or crankshaft sensor failed both sensor work together to control fuel timing and ignition timing.PCM has failed many things will cause that code.check sensor wiring connector for shorts or damaged.

Aug 07, 2013 | 1995 Dodge Ram

3 Answers

My 2005 dodge neon sxt wont start, no spark, changed cam shaft sensor, coil is good, cant find the crankshaft sensor, also wondered if it could be the timing belt, what do you think?


the crank sensor is on the back side of the engine just above the oil pan there will be two sensors there one is the crank sensor and the other is oil presser sensor. All so check the wires from the crank sensor to the cam sensor. If you think it is the timing belt pull the cover and check it. hope this helps.

May 22, 2012 | 2005 Dodge Neon SXT

1 Answer

Keeps blowing fuel pump fuse on my 2001 dodge van 5.2 after driving a few miles


These trucks are bad to chaff wires.if it runs 15 -20 min. in park but blows the fuse within a few miles of driving you almost definitely have a wire shorting out. this can be tedious to find. good luck

Nov 10, 2011 | 2001 Dodge Ram 2500 Truck

1 Answer

1998 dodge stratus fuse fuel pump ignition keeps blowing out i replaced it an still keeps blowing out?


The fuel pump is burned out or a wire is shorting to ground. If the car was working fine then the fuse burned out then it is probably the fuel pump..

Jun 04, 2011 | 1998 Dodge Stratus

1 Answer

Ram 1500 5.2l auto starts but after a few seconds


swap the asd relay with the fuel pump relay and see what it does then

Jan 22, 2010 | 1996 Dodge Ram 1500 Club Cab

1 Answer

1997 neon, fuel pump fuse keeps blowing


I had a neon that did this in my shop. I found one of the wires to the Oxygen sensors was melted near the exhaust and when you would give it gas the exhaust would flex and short out the o2 sensor.

Jun 11, 2009 | 1997 Dodge Neon

1 Answer

No spark


TRY THE THROTTLE BODY POS SEN AND THE COMP

May 25, 2009 | 1994 Dodge Ram

2 Answers

2001 Dodge Ram 1500 Won't Start


Have you checked the codes?
Mine was a faulty coil.... Twice. I made a heat shield for the second one.

Sep 10, 2008 | 2001 Dodge Ram 2500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

477 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...