Question about 2001 Chrysler Sebring

1 Answer

Blower fan only runs in high(#4)

Blower fan for a.c & heat only runs in high (#4)

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Chrysler Master
  • 3,854 Answers

The blower fan resistor has gone bad and needs tobe replaced, You can go to Auto Zone and buy the new blower fan resistor for much less then the dealer and Auto Zone will have the step by step instructions to replacing the blower resistor with common tools, Good luck and hope this helps. keep me posted, be glad to answer any other questions you may have. 

Posted on Jul 29, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1977 Buick blower / fan comes on however NO heat blower / fan also blows very low.


Buick LeSabre Heater - RepairPal

repairpal.com > Problems > Buick > LeSabre
Buick LeSabre Heater blows only cool air...even w/ defroster on. This is a ... Heater fandoesn't come on . ... The blower works but there is no heat coming out.

Blower Motor Problems ' Auto Repair Help - YouTube

? 4:22
https://www.youtube.com/watch?v=2vmfxYg8LoY
Sep 27, 2009 - Uploaded by mgittelman
The blower motor is a common heater/AC repair within the skill level of ... However if the power wire is a single light purple wire and the ... for blower motor and fuel and relay good but no powercoming on both any ideas? ... my o5 seira, when i start the engine with the air switch on it blows my blower fan ...

Car Air Not Blowing, Heat & Air "How to" Test Testing ...

? 6:22
https://www.youtube.com/watch?v=hgar6Q1lV6A
Apr 5, 2013 - Uploaded by Fixbook
Here I show how to determine the problem if your air, or blowermotor is not ... Click here to check out the the "Car Runs on 2 cylinders" series: ... How to Fix Over-Heating engine & No Heat in car - Buick (2000 yr) Park Ave . ... Car fan / AC only works on high - Replacing the Blower Resistor - Duration: 4:24.

Buick Park Avenue Questions - NO HEAT!!! - CarGurus




Jan 30, 2016 | 1977 Buick Electra

1 Answer

I have a 2002 Acura. While driving yeaterday, with the AC on high and fan on high, the fan turned off. Will not come on even heat mode, no fan at all. I checked 4 different fuses and they were all g


The fan is located behind the glove box, above the passengers feet. The 2 most common failures are the blower motor and the blower resistor. This system is a switch to ground setup. Unplug the blower plug and see which wire is hot, it should always be with the key on. With the car running and the fan switch on, hit the blower with the palm of your hand. If it comes on, it is bad. the brushes wear out. Also you can unplug the resistor, and ground the output wire at the blower, or resister. to see if it works.

Jul 01, 2014 | 2002 Acura TL 3.2 Type S

1 Answer

In cold temp,heater motor do not run


you mean low heat. at all ducts with full fan speed and blows hard,
here is the correct order.
1: engine at 180F or more holding, a absolute must.
2: fan runs at full speed on HIGH, (sounds like it)
3: fan actual blows (felt) at full speed, to any vent, try all vents.
4: now heat, will happen, if not, the dampers are closed or wrong.
damper can be complex on newer cars,they have motor controlled damper servos';

is this just blower fan dead? problem. on high, if yes say so.

Jan 26, 2014 | 2008 Suzuki Grand Vitara

2 Answers

01 grand.prix ac fan switch only works on high. has a duel temp controller when you turn fan off the only way fan comes back on is to move the temp controller levers


Hi!!
When the Blower Motor Resistor (controls blower speeds) goes bad, the blower motor works only on HIGH SPEED. REPLACE IT.
BLOWER MOTOR RESISTOR Removal & Installation
  • Disconnect negative battery cable.
  • Remove right lower instrument panel insulator panel.
  • Disconnect blower resistor connector located behind right side of dash.
  • Remove blower resistor screws and blower resistor.
To install, reverse removal procedure
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa!!

Feb 18, 2011 | 2001 Pontiac Grand Prix

2 Answers

Heat & AC blower (fan) does not come on. Just


if it worked on some settings and not on others then the blower motor resister has gone bad. its mounted on the heater box near the fan about half way up the heater box. they are cheap and easy to change. give that a try first

Jun 09, 2010 | 1996 Dodge Dakota

1 Answer

Warmed my car this morning heater was on high blower working and when i got in it 20 minutes later no blower 1993 honda accord ex 4 cyl


No fan or no heat?

sometimes if the fan blows you still feel the heat from the dash, but no blower to move the hot air, also is the car over heating?
regards
dan

Feb 26, 2010 | 1993 Honda Accord

3 Answers

Fan control only works on high in a gmc 2005 canyon


Replace the blower motor resister,it is mounted right next to the blower motor,it has a lug with about 7 wires on it.Just unplug it and remove two screws to remove the resister.This controls the speeds for the blower motor.The blower motor is the cause of the resister failure.Even if the motor seems to sound,and run fine,it is pulling to many amps.

Dec 08, 2009 | 2005 GMC Canyon

1 Answer

Fan for the a/c - heat will only work on high.


Common issue for many cars, Jeeps big time. Your "Blower Motor Resister" is defective. The reason for only 4 on the speed is the resistor controls the voltage going to the blower motor on the lower three speeds. This is a common problem, don't let anyone tell you it is the blower moter itself. The part should cost between $20-$40, depending on where purchased. The killer is getting it installed, some are easy to get at behind the glove box, others are up in the dashboard harder to get at. Chevy techs should be well aware of this, and be able to give you a good estimate of repair.

Oct 01, 2009 | 2005 Chevrolet Colorado

1 Answer

Blower on my 2004 Chev Colorado only works on high setting #4.


You need a resistor pack, which is likely located in the air box, near the blower motor.

Jun 29, 2009 | 2004 Chevrolet TrailBlazer

Not finding what you are looking for?
2001 Chrysler Sebring Logo

Related Topics:

314 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...