See if this link helps you find it.. where is the airbag module location is on 2010 mitsubishi lancer gts...
SOURCE: grade of oil
That info would be in his owners manual, I couldn't find it because the car is so new there is little info available. PLEASE tell him NOT to THROW AWAY the manual!!!!! So many people ask questions on this site, and the info is in the original owners manual, but most people seem to toss them out. If u don't want the manual, mail it to me!! Let me know if u can't find the info.
SOURCE: Lancer IPod connect cord
I own a 2007 Eclipse.
You can purchase the cord from the dealership, with the instructions for the I-Pod cord. Not hard to install on the Eclipse, takes about 30 minutes to install. This is the only known place to get this I-Pod connector.
SOURCE: Needing to locate the airbag control module '07 caliber
it is located behind the floor shifter in center console..under small piece of carpet
SOURCE: I have problem on airbag codes in mitsubishi lancer
Your first code is for low system voltage. If your battery has needed a jumpstart lately or replacement, this code will be set.
The second two codes are in relation to your rh side airbag (B1C2D) and curtain bag (B1B22) not being visible to the srs ecu. Has the car been apart for any reason, possible leaving harnesses unplugged? Was it in an accident recently and maybe the bags are missing? Were components removed for accessory installations (stereo, subwoofers, etc)?
The connector for the curtain bag is in the passenger side rear most pillar. The connector for the side airbag is under the passenger seat.
A weak battery can sometimes throw other miscellaneous codes like these, but it is not likely. If you clear the codes, the B1C2D and B1B22 should come right back.
If they do, and both bags are installed correctly, You can bypass them with a 3 ohm (three ohm) resistor and clear the code again. If the codes set again, there is a problem with the wiring leading up to the squib units. If the codes do not set again, there is a problem with the squib units.
SOURCE: How do i reset the srs airbag light in a 1996
you need to repair your airbag computer it has a crash data more info on http://www.vehix411.com
414 views
Usually answered in minutes!
×