Can you please tell me what size welsh plug I need for a Toyota 1997 RAV4, auto,

SOURCE: Spark plus

The gap is: 1.1 mm or 0.043"

Use Nippondenso PK20R11 or NGK BKR6EP-11 spark plugs.
AC, Champion, Bosch, Autolite, etc do not work well in this engine.
Stick to either of the 2 specified above.

SOURCE: need timing specs. 1997 toyota rav4

Chuck give toyota parts dept a call the can fax or print you a copy for your file make sure you have your vin available

SOURCE: removal and installation of an auto trans in 2002 toyota camry

1. Before servicing the vehicle, refer to the Precautions section.
2. Drain the transaxle fluid.
3. Remove or disconnect the following:
   
   Negative battery cable. On vehicles equipped with an air bag, wait at least 90 seconds before proceeding Battery Air cleaner assembly Throttle cable from the throttle body Cruise control actuator cover and connector, if equipped Ground wire Starter Speed sensor connectors, direct clutch speed sensor, and the park/neutral position switch connector on the transaxle Solenoid connector on the transaxle Shift control cable Oil cooler hoses Front side transaxle mounting bolts Front engine mounting bolts Oil cooler line mounting bolts from the front frame Upper transaxle to engine mounting bolts
   
   Fig. Tie the steering rack to the engine support fixture components, as shown-Avalon and Camry
   Front exhaust pipe Engine side covers and undercovers Both halfshafts Front side engine mounting nut Rear side engine mounting bolts (remove hole plugs) Left side transaxle mounting bolts Steering gear housing Front frame assembly Rear end plate mounting bolts Torque converter cover Torque converter retaining bolts Remaining transaxle mounting bolts Transaxle
   

SOURCE: Need a 1997 automatic Toyota RAV4 owner´s manual

Best place i have found to find the older manuals is on www.ebay.com just type in what your looking for and i am sure someone will be selling one.
hope this helped
Aaron

SOURCE: I need the timing specs. for my 1997 toyota rav4

ignition timing
10 Degrees

Special procedures are required for proper adjustments refer to emissions label (Under hood) or service manual
i just looked to see if i could copy and paste them for you and it wont let me.
it wont even let me look inside the book.

if your trying to setup the belt timing or the timiing gears you should get the info for that engine right out of the book.the book is only 21 dollars and will save you lots of time having it with you.book part number 92082 autozone has them and you may purchase it online.when you get every thing set just remember that both valves on number one cylinder should be closed with the piston of the same cylinder at top dead center.tdc.
be very careful as this is a very important step.
i hope this helps.

thank you
jm