Question about 1998 Chevrolet Astro

1 Answer

Clicking noise when accelerating - 1998 Chevrolet Astro

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 467 Answers

Check the transmission fluid, make sure its up to the mark.

Posted on Jul 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1988 Toyota Camry LE clicking noise during acceleration


start with premium gas or injector cleaner, could be a low octane ping. this may be hard to diagnose with out hearing the noise so the other thing i would have you do is remove the belts and run the engine. sometimes when a bearing in an alternator, idler pulley, a/c compressor or belt tensioner goes bad they can make a clicking noise. try to listen if the noise is coming from the belt area, the transmission area or some other spot. spin all the pulleys with the engine off and wiggle them to see if any are bad

Mar 31, 2014 | 1988 Toyota Camry

1 Answer

Clicking noise while reversing


put it on a hoist and visually inspect it then adjust the shift cable its moving to close to park position and the clicking is probably the park pin in the trans

Mar 10, 2014 | 2005 Chevrolet Tahoe

1 Answer

My vehicle makes noises when i accelerate


98% sure you have an axle problem. Might be wheel bearings depending on the sound. Bad axles will make a loud clicking noise, (click click click in rapid succession, espically while turning or under accleration) while wheel bearings will make a growling sounds.

Dec 09, 2013 | 1995 Nissan Quest

1 Answer

Clicking noise front wheel drivers side speeding up and getting louder when I accelerate and slowing down


Clicking noise from front end indicates a failing CV joint . It happens as the out of round balls fall into worn grooves in the joint as it turns The fix is to have them replaced

Nov 03, 2013 | Cars & Trucks

1 Answer

Clicking noise when accelerating


Check all belts pulleys could be injector prob

Oct 22, 2013 | 1997 BMW Z3 Roadster

2 Answers

Clicking only while accelerating, 5-speed


Could be a noisy valve or lifter in the engine, or an exhaust leak.
Can you make the noise happen by revving up the engine with the car parked ?

Jul 18, 2012 | 2002 Toyota Corolla

1 Answer

Clicking noise when accelerating, the noise comes


Double check.Is it coming from the transmission.A clicking noise under load may be a universal joint in the driveline or a c.v. joint in the front end.Both are cheaper than a trans.Check these 1st.Hope this helps

Aug 17, 2009 | 1994 Jeep Cherokee Country

1 Answer

Clicking noise when accelerating


Hello, this noise may be a stuck or warped lifter. This also can be a warped wrist pin or a thrown bearing. I would check and see if your oil is sludgy for a lack of better words for starters. I would check your oil level as well. Your valve lash can be off as well and this can be thrown off by this causing the ticking noise you are talking about. Is the noise coming from the top or the bottom of the motor. I hope this helps. Thank You.

May 20, 2009 | 1994 BMW 3 Series

1 Answer

Accelerated clicking/knocking noise when i start driving


sounds like your CV joints are worn out. If the clicking noise gets worse when turning then its a definite possibility. Also check the CV joint boots for splits as this can quickly wear them out. The dust mixes with the grease to form a grinding paste.

Apr 07, 2009 | 2000 Hyundai Elantra

Not finding what you are looking for?
1998 Chevrolet Astro Logo

Related Topics:

266 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...