A lady friend just GAVE me her car because she is tired of spending money all the time getting it fixed. She signed the back but, her signature is not on the front of the title. You are suppose to sign the front when you receive the title. Does she still have to sign the front before I sign the back or, does it matter? Thanks for any help. GOD bless.
SOURCE: tire pressure sign
Check the spare tire...The spare tire is also checked by the tire pressure warning system. Once the spare is inflated to the proper pressure, the light will go out.
SOURCE: Hit the gas and get a bucking, bucking and more bucking.
There's alot that can cause this problem. Check battery cables and clean. Drive to autoparts place for free diagnostic. It could be a throttle position sensor, EGR valve, bad gas, bad coil, bad plug wires. Just to name a few. Hopefully the diagnostic test will pinpoint it.
SOURCE: perfect tire pressure
The proper pressure is marked on the tire sidewall and on the sticker on the drivers door or door latch pillar.
SOURCE: I HAVE A 2001 DAEWOO NUBIRA THAT RUNS FINE MOST
If I recall correctly there was a recall on the camshaft position sensor. In some cases it would melt.
MAKE:
DAEWOO
MODEL:
NUBIRA
YEAR:
2001
DEFECT SUMMARY:
ON CERTAIN PASSENGER VEHICLES, THE CAMSHAFT POSITION SENSOR MAY MELT RESULTING IN A BURNING SMELL AND VISIBLE SMOKE, WHICH MAY SUBSEQUENTLY LEAD TO THE MELTING OF THE CAMSHAFT COVER AND THE CAMSHAFT POSITION SENSOR WIRE HARNESS.
CONSEQUENCE SUMMARY:
THIS COULD POSSIBLY CAUSE AN UNDERHOOD FIRE.
CORRECTIVE SUMMARY:
DEALERS WILL REPLACE THE CAMSHAFT POSITION SENSORS AND INSTALL AN ADDITIONAL FUSE. THE RECALL BEGAN ON SEPTEMBER 7, 2004. OWNERS SHOULD CONTACT DAEWOO AT 1-877-362-1234, OPTION 6, OR FIND A LOCAL DEALER THROUGH THEIR WEBSITE AT WWW.DAEWOOUS.COM.
SOURCE: how to fix the dimmer switch on a 1992 Buick
the dimmer switch is located on the steering colum about half way down . It is kind of hard to see .. there is a rod that runs from the turn singal handle down to the dimmer switch . it could be off or missadjusted . will need to check it might need a flash light to see it . the dimmer switch adjust with two little bolts i think they are 5/16 so they will need to be loosen to adjust the switch and rod or they will need to be removed to relplace the switch . i think the switch should be under 25 dollars if you need to replace it and should beable to be found at any local parts store
Testimonial: "I Thank U 4the time u took2 try to help me out, Not sure if it will r will not help I'll check it out.I'm still pray'n that it will. GOD BLESS U SIR.."
31 views
Usually answered in minutes!
×