Cars & Trucks Logo

Related Topics:

Anonymous Posted on Oct 08, 2017

Hard downshifts in a 2008 Cadillac SRX 2 wheel drive. Does it intermittently; also does it at times when shifting into drive after backing up.

1 Answer

Marvin

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Cadillac Master 85,242 Answers
  • Posted on Oct 31, 2017
Marvin
Cadillac Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jun 20, 2008
Answers
85242
Questions
28
Helped
29056414
Points
266281

1st have the system computer scanned for fault codes, if the fluid is original have the tranny serviced, if that doesn't fix it and it has no fault codes you may need an overhaul.

5 Related Answers

Anonymous

  • 2 Answers
  • Posted on Nov 29, 2008

SOURCE: part time light on when in 2 wheel drive off when in 4 wheel driv

I have a 2002 Jeep Liberty I had the same, there's a switch underneath the vehicle for the cable near the 4 wheel drive shaft, I had a transmission shop replace mine and that took care of the problem, I think the total cost was about $120.00 but that included labor.

Will

Ad

Anonymous

  • 4 Answers
  • Posted on Jan 07, 2009

SOURCE: 4 wheel drive not engaging

the shifter cable has broke and the cable cost about $40.00

Anonymous

  • 295 Answers
  • Posted on Apr 01, 2009

SOURCE: 1999 Dodge Durango 4x4 stuck in 4wheel part time

The transfer case shift soleniod that engages the transfer case is sticking .
I would take it to the shop and have it checked out.

Jonah Oneal

  • 14092 Answers
  • Posted on May 02, 2009

SOURCE: cant move transfer case shifter from 2 to 4 wheel drive

go to car wash spray back wheels enough to remove dirt.

Anonymous

  • 56 Answers
  • Posted on Jul 13, 2009

SOURCE: My 2004 Cadillac SRX has intermittent pinging or

The pinging noise that you hear is detonation occuring in one or more of the cylinders. The dealer suggested to move to a higher octane inorder to prevent this because the higher the octane the higher the prevention of Detonation.

The Probable cause of the pinging, would be that you refilled with a bad batch of gasoline. Premium should be used in this vehicle no matter what. Due to the clearances of the heads and valves in the motor. And also due to the material used to make the cylinder heads, if severe detonation occures then the valves could be damaged.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Cannot find oil plug to change oil on cadillac srx all wheel drive 2011

The plug is a 15mm bolt. It is positioned on the corner point on the rear passenger side of the oil pan. The exhaust has a bend at that position so a ring spanner will be easier than a socket. have a look at the video link so you know what your looking for.
2013 CADILLAC SRX OIL CHANGE RESET OIL LIGHT RESET 3 6L SRX SERVICE LIGHT
0helpful
1answer

2008 cadillac srx fixing or replacing light bulbs rear license plate

You might be able to access it if you stick your hand up inside the rear of the bumper.
0helpful
1answer

Where is the knock sensor located on a 2004 Cadillac srx v6 engine 3.6L

No sir, on the ly7 HFV6 3.6l in the 04-09 srx and cts the knock sensors are located on the sides of the engine block. Bank 1 and two are visible fringe wheel well. Not to hard to get to with a 3/8 drive 13mm socket, universal joint, and short extension. I would also check the connector with a multi meter while doing this job to ensure you have a good connection and harness is not damaged. Best of luck!
0helpful
1answer

How to change front turn signal bulb on 2008 SRX Cadillac

Nope don't need to drop the whole light assembly. I just took the wheel and inner cover off, then the 6 torx screws that hold the light hosing together , replaced the turn signal bulb and good to go!!
0helpful
2answers

Engine power reduced (came on) 2008 srx wad model

My 2008 SRX also had this problem, at first I would turn the engine off and that would fix the problem, but then both the check engine light and the reduce engine power light would come right back on. I brought it to my local mechanic and the code that came up was for the timing chain or the crank shaft. They checked with cadillac and they had problems with timing chain so that was replaced. It was fine for a few days and is now doing the same exact thing. Can anyone help?
0helpful
1answer

Change turn signal bulb 2008 srx

Front turn signal bulb replacement 2008 SRX . Jack up car & block . Remove front wheel & front half of the wheel house assemble. There are about 7 plastic pull rivets that have to be removed . Pull out the wheel house . Remove turn signal & driving light cover held on by 6 # T10 torx screws . Twist out socket & replace bulb # 3757NAK . Should take about 45 min.
Not finding what you are looking for?

78 views

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...