Question about 1992 Jeep Cherokee Sport

1 Answer

I need a 1990 Jeep Cherokee Sport Liftgate lock cylinder diagram. The paddle on the end of the cylinder broke off and i need to take it apart and fix it. I need to know how to disassemble the whole cylinder.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 35 Answers

Go online to haynes automotive manual website and you will most likely see the complete diagram there. if not go to your local library and you can get the info there.

Posted on Jul 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to fix locked liftgate on 2008 jeep grand cherokee ?


first is diagnosis.
you examine and test it. to see if its electrical or mech. failure.
and once discovered that follow that to logical conclusions.

Jul 08, 2014 | Jeep Grand Cars & Trucks

1 Answer

To JTurcotte - Your discussion and directions on how to repair the 1990 Jeep Cherokee srteering column were very good. I have a similar but not exact problem. The key would not come out of the...


WHEN YOU INSTALL NEW LOCK CYLINDER, TURN THE KEY TO THE LOCK POSITION. INSERT THE LOCK CYLINDER INTO THE HOUSING FAR ENOUGH TO CONTACT THE DRIVE SHAFT FORCE IT INWARD AND MOVE THE IGNITION SWITCH ACTUATOR ROD UP AND DOWN TO ALIGN THE COMPONENTS. WHEN THE COMPONENTS ALIGN, THE CYLINDER WILL MOVE INWARD AND THE SPRING LOADED RETAINER WILL SNAP INTO PLACE LOCKING THE LOCK CYLINDER IN THE HOUSING.

Sep 11, 2011 | Jeep Cherokee Cars & Trucks

1 Answer

1999 Grand Cherokee Limited Jeep anti-theft system had shut all electronics down and engine will not start. what can I do to reset the system....


The 1996 Jeep Grand Cherokee Laredo Anti-Theft System is equipped with Vehicle Theft Security System (VTSS). VTSS system monitors vehicle doors, hood, liftgate and ignition. If an attempt is made to enter or operate vehicle without proper disarming of system, vehicle horn will sound, headlights, taillights and parking lights will flash, and engine will be prevented from running.

The following wiring diagram and electronics circuit contains detail schematics of The 1996 Jeep Grand Cherokee Laredo Anti-Theft System. Herein you will find interconnection between electronics parts of the system such as body control module, auto headlamp light sensor. VTSS led, driver door module, passenger door module, cylinder lock switch, junction block, power distribution center, and grounding. Herein you will learn also how the Vehicle Theft Security System works, removal, installation, testing and troubleshooting procedures.

Try HERE.

Also, remember that here can find the Jeep Grand Cherokee Service & Repair Manual.
Hope help with this.

May 03, 2010 | 1999 Jeep Grand Cherokee

1 Answer

How do i remove the lock cylinder from the passenger door of a 1990 Jeep Laredo. need to have it rekeye. a diagram would be nice.


Remove linkage rods from lock and slide clip that holds it to door skin off. Lock is then out! it's more work getting the panel off than it is to remove the lock itself.

Sep 02, 2009 | 1990 Jeep Cherokee Limited

1 Answer

2000 jeep cherokee sport fuse diagram


Likely you are looking for a 30 amp circuit breaker...(Looks like a small rectangular metal fuse) But...if the power door locks work, i don't think that it's bad (serves locks & windows) My diagrams show a bunch of diodes and resistors inside the master (drivers) door switch, but I've had a few apart and never saw any. (embedded?) Personally I don't see anything that shows me reliability built into the switch...It's a really "iffy" design (one in my niece's Jeep only works when the sun shines on the drivers door) There is also a control module associated with the windows but I've never needed to replace one and the manuals never tell you where they are!
Check power at the switch and check harness where it goes through the rubber boot between the door and body. at least 80% of problems I've seen are either the switch or that wiring. Wires can be spliced and you can get a decent used switch at most scrap yards.
Good luck...glad they aren't stuck down!!!

May 31, 2009 | 2000 Jeep Cherokee

1 Answer

Liftgate emergency release cannot be found


2/3 of the way down this page with pictures

http://www.wjjeeps.com/liftgate.htm

All WJs feature an emergency unlock/lock switch lever for the liftgate. Should the liftgate become locked and unable to be opened due to a switch or circuit failure, a manual unlock/lock lever is accessible behind a small panel on the interior trim panel. As shown in the photos above, the lever can be moved up or down to unlock or lock the liftgate door.

Jeep Grand Cherokee WJ Liftgate trim and components

May 23, 2009 | 2008 Jeep Cherokee Grand

1 Answer

Rear Hatch will not open on my 95 Jeep Cherokee sport


You need to go to a locksmith and purchase a new lock cylinder. Remove the retainer clip from the old cylinder from the inside of the hatch.

Apr 29, 2009 | 1995 Jeep Cherokee

1 Answer

Unable to open liftgate on 1999 Jeep Cherokee with key or remote


Its the locking system on either side that not completely locking. A bump with the should on either side should fix it. I lived with this problem for a couple months, and every time I just gave a bump with my shoulder on the left side...Then i just finally sprayed some WD40 on the locking mechanisms on both sides...Bam..fixed

Mar 21, 2009 | 1999 Jeep Cherokee

1 Answer

2002 ford escape liftgate wont lock/unlock


the electronic sensor could be bad or the lock is physically jammed.

Feb 09, 2009 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...