Question about 1997 Toyota Tacoma

1 Answer

Clutch not slipping .. wont disingauge some times with out double clutching

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 672 Answers

Check your clutch master cylinder for proper levels, inspect clutch sleeve for proper travel and leaks. If no leaks are detected and fluid levels are good, try bleeding the system. If this doesn't work, possible master cylinder or clutch sleeve problem. Hopefully this helps

Posted on Jul 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I no if I have clutch problems


clutch problems ae indicated by slipping ( engine rpms rising but not going ant where), slipping may be a faulty clutch master cylinder, shuddering as you let the clutch out ( clutch plate covered with grease /oil ---OR--- faulty engine mounts. pedal to the floor is a problem in the hydraulics or a cable failure. A cable failed and jammed will also cause a slipping clutch
so to summerise ,if the clutch is slipping --check out the hydraulics and cables. If it is shuddering --check out the engine mounts. Basically if it starts to slip after being driven for a period of time then it will be the clutch pressure plate /clutch plate worn

Dec 22, 2014 | 2008 Audi A3

1 Answer

Truck wont go when I release the clutch.


You need a new clutch. The clutch disc has worn out, now it's slipping on the flywheel. Clutch kit: new pressure plate, new clutch disc, new clutch release bearing, and new crankshaft pilot bushing- about $150-200, somewhere in that range..

Dec 24, 2013 | 1989 Ford Ranger

1 Answer

Subaru justy wont go into any gear


when was the clutch plate last replaced was it lately and the problem just started after the change
next there is a bush/bearing in the center of the crankshaft that failes/ dry and that seizes in the input shaft of the gear box and makes the clutch useless as it drives the box all the time
another thing is any oil or grease on the clutch lining will stick the plate to the flywheel face and cause a problem
if the clutch plates are old , the damper springs can come out /break and intere with the flywheel mounting bolts
removing the transmissions and checking the clutch assemblies will reveal the reason for the failure

May 21, 2017 | 1990 Subaru Justy

2 Answers

When i am driving useing the clutch my car doesn't get up to speed


possible clutch wear , if the clutch is worn, adjusted wrong, or slipping, this same thing will happen, depending on how many miles are on your vehicle, it may be time to replace the clutch ., you don't state if the motor seems to be running smoothly ,, or the same as it was prior to this problem,, if it seems ok, its time for a new clutch

Sep 21, 2011 | Ford Focus Cars & Trucks

3 Answers

Clutch is slipping and needs adjustment how


Sorry but all the newer cars don't have a adjustment's they are all hydraulic clutches. They have adjustments for the cable but it wont help the clutch. It needs a new clutch and maybe a flywheel if it's burnt and slippin. I hope this helps ya.

Oct 31, 2010 | 1999 Hyundai Accent

1 Answer

2000kia sophia clutch slips


If it's slipping it's near the end of its life and you'll have to change it. Make sure to inspect the rear main seal - most of the time a clutch slips because of wear but a rear main seal leak will allow oil to leak onto the disc and it'll slip. In either case you'll need a new clutch but if the seal is leaking it'll ruin the new one too.

Feb 26, 2010 | 2000 Kia Sephia

2 Answers

Will not shift into grears rite


sounds like a clutch problem, more than likely a worn bush, wich should be found on the clutch cable under the bonnet, it is a rubber ring wich smooths shifts. if the bush seems okay then you more than likely have a 'stick' than a 'slip'. clutch problem. this means your clutch is having trouble disconnecting from the fly wheel. however dont rule out a 'slip'. whatever the problem is i suggest replacing the clutch as it is obviously quite a serious problem.

Nov 24, 2009 | 1993 Isuzu Amigo

1 Answer

1985 Honda Accord clutch slip and other advice


try adjusting clutch first.if it still slips in 4th and 5th.then you have to change clutch pressure plate and clutch release bearing and check condition of fork.

Jun 07, 2009 | 1985 Honda Accord

1 Answer

Clutch is slipping on my 1995 BMW 318ti


to be fully honest if its doing this its wont be nothing to do the the fluid, the clutch plate will be sticking on the shaft untill you get it upto a higher speed,, that means you will need a complete clutch fitted, because as its slipping it is burning the clutch plate away,, you have new clutch fitted and car will be great. . playing away with things only makes matters worse and time comsuming ..

Apr 03, 2009 | 1999 BMW 318 ti

1 Answer

Clutch slipping


A clutch is usually adjusted from underneath the car if it's a mechanical clutch.

Your comment that there is very little play at the top indicates an improperly adjusted clutch. You should have about 1/2 - 3/4 inch of play before feeling the clutch in the pedal.

Jan 24, 2009 | 2003 Nissan 350Z

Not finding what you are looking for?
1997 Toyota Tacoma Logo

183 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...