Question about 2000 Chevrolet S-10

1 Answer

2000 Chevy s10 2.2L very rough idle at low rpm

2000 Chevy s10 2.2L 4 cyl engine. Truck was running fine and recently deveolped a very rough idle and miss at low rpm when standing still. Once its past 2000 rpm the idle seems to smooth out. Installed plugs and air filter, but didn't help at all.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 65 Answers

Run a fuel pressure test, if that checks out fine it may be a faulty coil pack or ignition control module

Posted on Mar 01, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 F-350 w/460. Why does it run roughly after warmed up?


Does it run rough at hot idle ? How many miles ? Any recent work done on engine ?

Nov 05, 2015 | Ford Cars & Trucks

1 Answer

96 chevy s10 ss runs rough misfires no engine codes


I am thinking it is your distributor. I had this happen just a few weeks ago. Check with local junkyards as I found a used(almost brand new) distrubutor for 100.00 opposed to almost 300.00 new. Same exact problem and also changed each thing you listed prior to finding out it was my distrubutor. My truck runs like it did before the issues started.

Nov 08, 2012 | Chevrolet Cars & Trucks

1 Answer

Starting off truck is sluggish but slowly gains rpm then runs fine


SOUNDS LIKE YOU NEED TO HAVE YOUR TIMING CHECKED. EVEN THOUGH THE TRUCK IDLES FINE IF THE TIMING IS OFF BY ONE DEGREE IT CAN CAUSE LOW POWER.

Jun 29, 2012 | Toyota Pickup Cars & Trucks

1 Answer

Texas 1995 Nissan cuts out at 2000 rpm's


note that there is no mention of any fault codes so unless the fault codes are read then fixing by guessing is frustrating and costly

Jul 08, 2017 | 1995 Nissan Pickup

1 Answer

I have a 1999 chrysler sebring coupe with a 2.5 v6 engine.My problem is the car idles rough and misses at low rpm.But it runs good on the road no problems. When i let off the gas like going down a hill or...


first of all, a 2.5 is a 4 cyl.. I noticed you stated it was a 6 cylinder, 6 cyl. are 3.0. it is important to know if it is a 4 or 6 cyl to correct this type of problem. this problem is either carburetor related or something the fuel line. try losening the gas cap and the drive to see if this corrects problem. could be vapor locked......mike

Jun 05, 2017 | 1999 Chrysler Sebring

1 Answer

Recently I had my 2000 gmc 2500 6.0 liter truck start running rough. I changed the spark plugs, checked the coil packs and replaced the fuel pumpand fuel filter. Still no change....Any suggestions?


ROUGH IDLING CAN BE CAUSE BY MANY THINGS.I AM LOOKING AT LEAKING VACUUM HOSES OR INTAKE MANIFOLD GASKET LEAK.DIRTY FUEL INJECTORS AND WORN ENGINE VALVES WILL CAUSE ROUGH IDLING.ALSO LOW IDLE SPEED CAUSE ENGINE TO RUN ROUGH.

Apr 18, 2010 | 2000 GMC New Sierra 1500

1 Answer

Won't start, engine wont rev above 2000rpm


Have the alternator tested. You are providing a low charge to the battery when you jump it and when taking it above 2K RPM requires more amperage resulting in the engine dying and the rough idle

Apr 23, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Rough idle stalls at low rpm's


hello first check your idle with the car running foot on brake see were your rpm reading is if your below 500rpm check your label underhood for your curb idle setting second see if theres a adjustment screw you can increase were your gas cable lever rest against your set screw underhood if you feel confident enough remove your iac motor idle air control valve if the bore were the end of the pintle extracts out to close has varnish builup our carbon it will stick creating vacuum leak type senario causing stalling rough idle sometimes even no start conditions good luck

Sep 14, 2008 | 1988 Honda Accord 4 Door

2 Answers

2005 GAm CAnyon Engine idle rough


there is recall because of this problem. the same thing ws going on with mine. contact your gmc dealership. it is a valve problem in the head.the recalll is not published but if take it to the dealer he can check to see if this the problem. this was a cyl. head problem.

Aug 03, 2008 | 2005 GMC Canyon

Not finding what you are looking for?
2000 Chevrolet S-10 Logo

3,406 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...