The brake light switch should be located at the base / pivot point of the brake pedal switch, under the dashboard. There may be two switches - one for the brake lights and one for the cruise control.
SOURCE: AC BLOWER FAN STAYS ON
When does it go off (the fan). I assume it does, sooner or later, go off? Some blowers (high-end vehicles) stay on a little longer to clear moisture, but if this just started (hasn't happened since day one) then I would assume it is a short (pray it isn't) or the blower cutoff relay/blower motor relay. If neither relay is available for that car, it could be built-in to the motor. Then, try to unhook the motor and put a tester on the connection plug going into the motor and see if you can get power with the car on, and watch it disappear once the car is turned off, that indicates it is the motor or the resistor atop the motor.
SOURCE: 2003 Hummer H2 overheats while idling in Park
NED TO HAVE THE CODES FOT THE CHECK ENGINE LIGHT READ.THE CODE WIL LEAD U IN THE CORRECT DIRECTION.GET BACK TO ME W/THE CODE.
SOURCE: change light on 2006 hummer h2
it can be easily changed by removing the plastic cover then u will see the light bulb, don't try to change it from the back, it wont open :)
SOURCE: 91 honda accord brake lights stay on replaced
are you sure you the adjustment to it is correct the button in the end of the switch has to be fully depressed to deactivate the circuit
SOURCE: 2005 h2 wipers run all the time
There was a recall on the suv`s but I`m not sure the h2`s were included.The fix was the replacement of the wiper motor module which is on the motor.All you have to do is remove the cover on the wiper motor and the module is there.Just unplug it and pry it out with a small screw driver.You can get a module from the dealership parts department.Just follow the directions.Hope this helps.Good luck.
481 views
Usually answered in minutes!
×