Question about 1998 Subaru Legacy

1 Answer

Where is the flasher for the directional signals located ?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

The flasher is integrated into a turn & hazard module under the left side of the dash

Posted on Jul 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the flashers located to replace turning signals in a 1996 nissan maxima


The combination flasher relay is located under the dash panel, next to the center console near the Automatic Speed Control Device (ACSD) control box. If the turn signals operate in only one direction, a bulb is probably burned out. If they do not operate in either direction, a bulb on each side may be burned out, or the flasher may be defective.

0c054d5.jpg

The flasher is located next to the ACSD control unit under the dash panel on the driver side of the vehicle

Hope this help (remember rated this). Good luck.

Feb 08, 2010 | 1996 Nissan Maxima

2 Answers

Where is the turn signal\hazard flasher located?


it's in the auxiliary relay box behind the glove box.

13350 is base part number on flasher

Feb 03, 2010 | 2003 Ford F250 Super Duty Crew Cab

1 Answer

Directional signals


needs a new relay flasher turn 4 ways on to try and locate under dash or built into 4 way flasher button

Nov 30, 2009 | Cars & Trucks

1 Answer

Where is the turn signal flasher unit located on a 2001 Chrysler Concord


here is the location of the flasher The Turn Signal and Hazard Warning Flasher is combined into one unit called a Combination Flasher (Combo-Flasher) The combo-flasher controls the flashing of the hazard warning system and the turn signal system. An inoperative bulb or incomplete turn signal circuit will result in an increase in flasher speed.
The combo-flasher is mounted to the in-line bracket which is located to the right of the Junction Block. The flasher can be removed by pulling in an rearward direction. The left under panel silencer duct must be removed to access the flasher. The combo-flasher is black in color for ease of identification

Nov 26, 2009 | 2001 Chrysler Concorde

1 Answer

Where is the turn signal flasher unit found on a 2001 Chrysler Concord


COMBINATION FLASHER LOCATION The Turn Signal and Hazard Warning Flasher is combined into one unit called a Combination Flasher (Combo-Flasher) The combo-flasher controls the flashing of the hazard warning system and the turn signal system. An inoperative bulb or incomplete turn signal circuit will result in an increase in flasher speed.
The combo-flasher is mounted to the in-line bracket which is located to the right of the Junction Block. The flasher can be removed by pulling in an rearward direction. The left under panel silencer duct must be removed to access the flasher. The combo-flasher is black in color for ease of identification

Nov 26, 2009 | 2001 Chrysler Concorde

1 Answer

TURN SIGNAL, BRAKE & HAZARD LIGHTS


No Turn Signal Operation (blinker)The turn signal lights in your car are a basic electrical system that controls the front and rear blinker lights to alert the intended direction of the vehicle. We have listed some of the most common problems and repair troubleshooting tips below:
Troubleshooting Procedure
To start troubleshooting this problem:
  • Turn the key to the on position (do not start engine)
  • Inspect the system fuse located in the fuse panel and replace if needed. If you cannot find the location of the blinker fuse consult your owner's manual or an online repair manual
  • When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher. If you cannot find the location of the blinker flasher consult your owners manual or an online repair manual.
  • 1b7f814.jpg

Jul 09, 2009 | 1999 GMC Denali

2 Answers

I'm looking for the turn signal flasher unit on a 1993 Buick LeSabre. I found the 4-way flasher which is clipped onto a support by the steering column but can't find the turn signal flasher. I bought a new...


The turn signal flasher is above the emergency brake petal and about 6 inches above, hid by a wiring harness. It is in a clip so pull it out and leave the wire hang to replace the new flasher. If you locate the fuse box drop it down by releasing the two metal clips left and right , the flasher will be directly above the left side of the panel.

Jun 08, 2009 | 1994 Buick LeSabre

1 Answer

Fuse location for directional and emergency signal


The TS flasher and 4 way flasher use different fuses. I'd test the flasher assembly located near the fuse box under the dash. One blown fuse won't disable both but a bad flasher module could,

May 03, 2009 | 2000 Toyota Camry

1 Answer

Cannot locate flasher for 1994 ford crown victoria


The flasher is the round most likely yellow but could be silver mounted in fuse panel. The hazard flasher is located on back side of fuse panel directly behind it.You can remove it and insert it in place of the turn signal flasher to see if it is bad.

Mar 16, 2009 | 1994 Ford Crown Victoria

2 Answers

Directional signals screwed up, but my 4 way flashers work.


For this modle and year the turn signal flasher should be mounted in a clip on the right side of the steering column support bracket. The hazard flasher is located under the instrument panel in the module block, on the right side.
Hope this helps,
Regards,

Feb 13, 2009 | 1995 Buick Regal

Not finding what you are looking for?
1998 Subaru Legacy Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...