Question about 1993 Ford Probe

1 Answer

Replacing the power steering pump?

Replacing the power steering pump on a 1993 Ford Probe?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,776 Answers

Go to the autozone website at and register your vehicle. It's free and you will have access to an online repair manual for your vehicle. The procedures for replacing the power steering pump for your car is there. ( I checked) Hope this helped and best wishes.

Posted on Jul 28, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I replace the oil pump on a 1993 Ford probe.

You will need a factory repair manual, you can buy access to one HERE

Jun 05, 2012 | 1993 Ford Probe

1 Answer

I have no spark and just replaced the rotor help

Check the wires to your coil, if you have power there and no spark from the coil replace the coil, if no power to the coil, then you may need to replace the ignition switch, which should be on the bottom side of your steering column.

Jan 18, 2011 | 1993 Ford Probe

1 Answer

My belt is squealing really bad on my 96 Ford Probe SE 2.0 liter, i replaced the power steering pump, the power steering belt and it is still squealing. Is it a pulley?

Often these vehicles have a spring loaded tensioner, which you would have released to replace the belt. When the spring in the tensioner gets weak, causes a squeak.

Oct 27, 2010 | 1996 Ford Probe

1 Answer

Fuse size for an inline fuel pump for 1993 ford 2.3 efi engine

There is no in line fuel pump. The pump is in the fuel tank. Check for power at the connector near the fuel tank. Cycle the key and probe the wires. I'm not sure what color the wire is . If you have power there the fuel pump is bad.

Feb 24, 2010 | 1993 Ford Mustang

1 Answer

I'm working on a 93 probe gt when I turn the ignition I get all the lights, fuel pump, bells but no cranking. Pulled the starter it's good. I can get it to run if I hot wire it from the solenoid to the...

have you replaced the ignition switch? not the key cylinder but the actual electrical switch, they are prone to this type of failure, pull the covers off the steering column and test the switch.

Oct 15, 2009 | 1993 Ford Probe

1 Answer

Could it be my fuel pump?

A fuel pump is not the problem, they either work or not, u are most likely having a loose of ignition spark, possible ignition module.

May 27, 2009 | 1993 Ford Probe

2 Answers

Access panel for the fuel pump on a 1993 ford probe

the 93+ probe's (2nd generation) DO NOT have an access panel under the seats, or anywhere. only the 89-92 probe's did (1st generation) To gain access to the fuel pump, you have to drop the gas tank. or get handy with a cutter, and hope you dont blow yourself up.

Jan 07, 2009 | 1993 Ford Probe

1 Answer

Where is the power steering sensor located on a 1993 ford ranger 4.0 super cab? (or is it called the power steering pressure switch?)

The power steering pressure switch as its called threads in to the power steering pressure hose most of the time it is close to the power steering pump, I have also seen them at the lower point of the pressure hose close to the rack and pinion.

Nov 25, 2008 | 1993 Ford Ranger SuperCab

2 Answers

Ford 1993 probe horn

The horn Button at the steering wheel is simply a switch. It grounds out when pushed causing the circuit to close, routing it though the actual  horn under the hood which is sitting there waiting to activate.

Jul 24, 2008 | 1993 Ford Probe

Not finding what you are looking for?
1993 Ford Probe Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers


Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides