Question about Ford F-100
Check your steering linkage components. Ball joints / tie rod ends should be stiff but movable. If they move freely or loosely, that movement is allowing the wheels to follow every dip in the road even if you're holding the steering rock steady.
Posted on Jul 28, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Dec 06, 2015 | Cars & Trucks
Sep 07, 2014 | 2004 Ford Expedition
Jan 04, 2013 | Cars & Trucks
Things You'll Need
the vehicle on a level surface and make sure the front wheels are pointing
straight ahead. Make sure the vehicle is in park (or in gear if you have manual
transmission) and set the parking brake.
the pitman arm from the steering box from underneath the front of the vehicle
by turning the holding bolt in a counterclockwise direction with an adjustable
wrench. Place a pitman arm puller (available at auto parts stores) over the
pitman arm and tighten the nut on the puller in a clockwise direction with an
adjustable wrench until the pitman arm loosens from the steering box shaft.
Remove the pitman arm and the puller.
the hood and loosen the lock nut on top of the steering box from the engine
compartment with an adjustable wrench in a counterclockwise direction.
a torque wrench on the steering shaft and turn the wrench one complete turn.
Make sure the torque reading is approximately 2 inch pounds. Tighten the
adjusting nut on top of the steering box (it comes out of the center of the
lock nut) in a clockwise direction with an adjustable wrench one half turn if
the torque wrench reading is too low. Loosen the nut in a counterclockwise
direction if the reading is too high.
the steering shaft with the torque wrench again. Make adjustments to the
steering box adjusting nut as described in Step 4, if needed, until the correct
reading is obtained on the torque wrench.
sure the steering wheel is in the straight ahead position and reattach the
pitman arm to the bottom of the steering shaft on the steering box. Tighten the
holding nut in a clockwise direction with an adjustable wrench until the pitman
arm seats into place.
the lock nut on top of the steering box with an adjustable wrench in a clockwise
direction. Close the hood
Jul 24, 2012 | 1993 Buick LeSabre
Jul 19, 2011 | Jeep Grand Cherokee Cars & Trucks
Sep 26, 2009 | 1999 Chevrolet Suburban
Jun 22, 2009 | 1996 Ford Bronco
Jun 08, 2009 | 1979 Pontiac Firebird
Apr 21, 2009 | Chevrolet Astro Cars & Trucks
236 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: