Haven't got any cruse or backup lights or turn lights where's ele power and no ele to fuses 3 4 7 8 how do I fix?

Backup Lamps
The TURN SIG fuse in the console fuse block supplies battery positive voltage to park neutral position switch. When the gear selector lever is in the REVERSE position, power is supplied to both of the backup lamps. The backup lamps are grounded at G401 and G402.
Do you know what DTC'S - diagnostic trouble codes are ?
DTC B2552
The body control module (BCM) controls the backup lamp relay. The BCM grounds the backup lamp relay control circuit energizing the backup lamp relay. The BCM connects directly to the center console fuse block with no external wiring between them.
DTC B2553
The body control module (BCM) controls the backup lamp relay. The BCM grounds the backup lamps relay control circuit energizing the backup lamp relay. The BCM connects directly to the center console fuse block with no external wiring between them.
Backup Lamps Always On

1. Turn ON the ignition.
2. Shift the gear selector lever to the REVERSE position and then to the PARK position.

Do the backup lamps turn on in REVERSE and turn off in PARK?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
Go to Step 3

3

Remove the backup lamps relay.
Do the backup lamps turn OFF?
Go to Step 5
Go to Step 4

4

Repair a short in the backup lamps relay switched battery positive voltage supply circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you complete the repair?
Check the back-up lamps relay #45 in the center console fuse/relay box .
Fuse Block - Center Console
Inside of console, behind the right console access panel

Check

I would check all fuses to see if any have blown.

The most common problem on this vehicle is the sensor right on the master brake cylinder the seal goes out and brake fluid gets right in the sensor ruining it that is the most common problem lete no if it helps

Your going have check the fuse for the brake lights if the fuse is good check to see if threr is power at the brake light switch when you fix your brake lights the cruise will work. As for the trailor plug your going to have to check the wire conections to the plug.

could have a break in the wire going to the blinker part. would have to have that checked via a multimeter to make sure all connectors are getting power

well the cruse control has a cruse control module check that out but for the the turn signals and dash light if you already replaced the fuse maybe the lights burned out or you have a bad ground somewhere

Need to check the brake light switch. ok down by the brake pedal there is a switch that tells the lights to turn on when you push it. almost always easy to fix and you can buy a switch aftermarket for around $10 bucks. If you have cruse control a good way to check the switch is to run the cruse con and try to get it to stop crusing by pushing the brake pedal if it keeps going thats your problem. hope this helps

I had the same problem with my 2003 santa fe. Do you have any brake lights out in back? Weird as it is, as soon as I fixed a burned out brake bulb, my cruise worked again. The only relation I can think of is that tapping the breaks causes cruise to turn off - so maybe a broken brake/tail light passes a singal to cruise control from some reason???

one of 3 problems.....check the fuse. the bulbs inside are burned out(what a pain) or there is a bad wire... i really hope for your sake its the fuse