Question about 1986 Toyota Pickup 4WD

3 Answers

Where is the fuel pump located. 1986 Toyota 4x4 PU 22RE

My 1986 Toyota PU 4x4 (22RE) is fuel injected and also has problems starting up. The fuel pump has never been replaced and I want to replace it with a new one. Where is it located and would it be hard to repair myself? What do they cost? And is it ok to purchase an after market fuel pump oppose to getting one from the dealer?

Posted by on

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 68 Answers

The fuel pump for your truck is in the gas tank. They cost about $142 at Autozone. It's not that hard if you have a basic ability with tools and a little help to raise and lower the tank. Of course you'll need to drain the tank before you start.

Posted on Jul 28, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Fuel pump is located in the fuel tank .yes buy after also change fuel filter

Posted on Jul 28, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 25 Answers

Most likely in the gas tank. depending on your mechanical abilities its not really difficult to replace. You will have to drop the tank or remove the bed. Once you drop the tank with the least possible amount of fuel in it, you will see a round plate with 2 or 3 fuel lines coming from it. This is the top of the fuel pump. You can probably get one for around $100us or less.

Posted on Jul 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Toyota problems fuel pump leaking


Replace rubber lines to injection fuel pump.

Jun 16, 2014 | 1986 Toyota Hilux 2200

1 Answer

1984 toyota pickup 22re fuel injection is not getting fuel to the cylinders


Most likely a fuel pump problem, locate the diagnostic check connector under the hood and turn the key on then put a jumper wire between the terminals FP and B+ if it start then the fuel pump is ok and the problem may be the EFI relay or efi fuse

Sep 28, 2012 | 1984 Toyota Pickup Deluxe

1 Answer

I changed my 1986 Toyota pickup engine, when it was all done i tried to turn it on and the gas pump wasn't pumping enough gas so i bought a new one and installed it, apparently now the pump has to much...


1986 is it fuel injected or carburator? Ill assume it fuel injected. New engine? Too much fuel pressure?
If its fuel injected is not going to be too much fuel pressure. There is a fuel pressure regulator that regulated the pressure.Because its a replaced engine what is the firing order? There will be 2 of them 1342 and 1432, You'll need to check the timing and the firing order. Bring the engine to top dead center, use the mark on the front pulley. take spark plug# 1 out.Is the piston up? Top dead center is the piston up and crank timing mark on zero( 0). remove distributor cap is it at a position to fire # sparkplug wire to cylinder? If not youll need to set it there. Because you are stating it shakes alot you not in the right firing order. let me know

Apr 26, 2011 | Toyota Pickup Cars & Trucks

2 Answers

1986 nissan truck starts fine runs a min. then stops.Driving it you have to keep pumping gas for it to keep running


Hook up a fuel pressure tester start and let run until dies and check pressure if plenty of pre.ssure If this is a carberated engine tune your air and fuel mixture jets located in front bottom of the carb.., hook up vacuum and set to your hightest reading and then set your idle screw to prefered idle which is around 8 RPM If this is a injected system hook up a fuel pressure guage and start engine and let it run until it stops keep an eye on pressure to see if the pressure drops or stops if so replace fuel ****

Mar 05, 2011 | 1986 Nissan Pickup 4WD 1986

1 Answer

1986 chevy pu 1/2 ton.2 wheel drive 4.3 litre v-6. My Truck sometimes starts,sometimes runs sometimes just turns over but won't start..I have replaced cap,wires.plugs,rotor,coil,battery and ignition...


Check your fuel pressure. This will tell you if you are getting enough fuel. If you are not getting the proper pressure either your fuel filter is clogged or your fuel pump is failing and needs to be replaced.

Sep 23, 2010 | 1986 Chevrolet Chevy

3 Answers

I have a 1985 toyota pickup (fuel injected)with a 22re engine, it will run on starting fluid, when i spray it but it wont run otherwise, just put in a new fuel pump, thanks for youre help,


Alright, i have a 1987 Toyota 4x4. it has a 22RE full injected motor..it was able to run, but it was running rich, and idling pretty eratic..and then now..it only starts up..and dies. after like 5seconds. 

Jun 15, 2010 | 1985 Toyota Pickup

1 Answer

The truck was sitting for about 10 years, everything electrical works, i replaced the spark plugs, wires and rotor before even trying to turn it over, the engine wants to turnover and the spark plugs are...


if its carberated, u need to clean that out. if its fuel injected, replace the fuel filter. if it stil dont work. then u have a fuel injector problem

Mar 05, 2010 | 1986 Toyota 4Runner

1 Answer

Where is the fuel filter located on my 86 4wd (22re)


You're going to laugh when you hear this...not! It's under the intake manifold, bolted to the side of the engine block. It's a real pain to do.

Jan 12, 2010 | 1986 Toyota Pickup 4WD

Not finding what you are looking for?
Cars & Trucks Logo

1,325 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...