Question about 2003 Nissan Pathfinder

1 Answer

While driving a little black box dropped down near my brake peddle ,so I pulled off the road and tucked it back under the dash, it is about 2in X 5in and about 1 in deep,with a rounded circle on it slightly convexed outward and a small hole in the to of the circle like a microphone or something it also has a red and black wire and a orange ,white and black wire set of wires coming out of a connector on the side of it near the middle ,what it it a remote stater box or and alarm box or what?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 952 Answers

Hi,

Thanks for using FixYa!

What you found is the alarm module. Just tuck it back in securely. Nothing to worry about right now...

Have a great day.
- HotRatchet

Posted on Jul 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

S max brake light switch location


That switch should be located at the upper section of the brake peddle arm. If you reach up under the dash, running your hand up the arm the brake peddle is attached to... You will feel a small box with a button. THAT'S IT!!! When you push down on the brake peddle, it pushes that little button on the switch which makes the brakes lights come on. Just for kick though, make sure the brake light fuse is still good, before roll around on your floor board.
Good luck and Happy New Year,
Bill

Oct 17, 2014 | 2008 Ford S-Max 2.0

1 Answer

How to open hood of 2005 clk 350


It's easy. There is a little lever that you need to pull down and towards you (when seated) in drivers seat--located under the dash console, just to the right of the emergency brake release lever. The reason its hard to find, is that it is nicely tucked flush with the underside of the dash console, right about where your left knee would rub, if it stuck out, so it makes sense that its tucked away. But like anything, once you know where it is, its a piece of cake to find it.

Apr 20, 2014 | 2006 Mercedes-Benz CLK 500

1 Answer

My 1997 ford ranger a/c dash vents won't blow


Vacuum supply starts on the drivers side of the engine. There is a vacuum line going into the brake vacuum assist from the manifold. branching off of that line is a double line that snakes under the intake manifold, behind the valve cover, along side the valve cover on the passenger side headed to the front of the engine. Then it curves to the right side of the engine. One set of hoses from this line goes to a valve control (red and green i think). The other line goes to the vacuum storage ball, it should be black. The vacuum circuit continues out of the ball in another black line that snakes into the firewall. It goes under the heater core black box and disappears under it. Now go into the passenger compartment and drop the glovebox. look to the back right you will see a black and a white vacuum line coming out of the firewall. The black line is your vacuum supply from the engine. It goes up to a little rubber manifold. disconnect the lines coming from the dash switch and check for vacuum on the manifold where the black line is going in. The white line controls the cabin air intake under the glovebox and the thermostat shutoff under the hood. It should only have vacuum when the switch is in a certian position, AC probly. The other three lines coming off the rubber manifold snake behind the dash vent door assemble and come out near the gas peddle. The red one controls the dash vent. apply vacuum to the red hose and see if the vents go to the center dash position/AC. The yellow and blue? ones control the floor vent control near the gas peddle. yellow gives you half floor and half defrost. blue gives you all floor. you can use a small vacuum line to connect the black vacuum supply to each individual line on the manifold and check the function of each vacuum control assembly individually. I hope this helps. On my truck each control unit works fine when i apply vacuum to them individually but when I hook the dash switch up to the rubber manifold it goes to defrost. I tried changing the dash switch and the lines running from the switch to the rubber manifold and the vacuum ball under the hood, nothing works. I suspect I may have leak i just haven't found yet. next step is to get a vacuum gage and start checking the amount of vacuum i am getting at each vacuum line. I'm sure it is supposed to be getting a specific amount of vacuum and will not work if the vacuum drops below a certian level due to a leak in a line somewhere? God bless.

May 28, 2012 | 1997 Ford Ranger SuperCab

1 Answer

Truck stalls out about a mile down the road wont take fuel changed fuel pumps filter ing parts


Have you checked your enersha (probably spelled wrong) switch could be trigered off or bad .I think yours islocated under dash on left side of steering colom or some times under seat look for box about 2in by 2 in and about threequarters in thick with a little white button on it. Good luck

May 22, 2011 | 1988 Ford F 250

2 Answers

My shifter locks when i've just turned the car on and try to shift from park to drive. It moves to the right a little bit, but will not move down into reverse. Ideas?


There may be a malfunction in the shift interlock sys.
This sys. keeps the shift from being moved from park
unless the brake peddle is depressed. There are 5 fuse's, directly or indirectly related to the interlock system. Fuse #6 15amp in the fuse box under the hood on the left side. The next 4 are in the fuse box
behind the left side of the dash. Fuse #3 15amp/fuse
#18 15amp/fuse #16 20amp and fuse #4 15amp.
Check these first, before you move on to the brake
light switch, under the dash at the brake peddle.
And the shift lock solenoid, under the console left of
the shift lever. Hope this helps.

Mar 22, 2010 | 2007 Subaru Forester 2.5X L.L. Bean...

2 Answers

My rear brake lightas are out and i replaced the bulbs on both sides and they are still not working


it may be the switch whitch is located under the dash driver side right above brake peddle arm. when you press the brake peddle the switch button comes out causing the lihts to come on. may just need a little lubricant.

Jul 01, 2009 | 2006 Hyundai Sonata

2 Answers

Brake lights stay on after releasing peddle


buy a can of silacone oil and spray it up under and behind the brake pedal its most likly the small switch sticking do not spray front of pedal you could cover this with an old rag to prevent overspray this will solve your problem.adrian

Feb 18, 2009 | 1990 Chevrolet K2500

1 Answer

Automatic transmission shifting problems


20 year old vacuum hoses are done. Replace all you can. The little plastic ones too. They control everything, transmission, computer, fuel, brakes, everything.

Jan 10, 2009 | 1989 Toyota Camry

1 Answer

Brake lights won't turn off


sounds like it is a brake light switch located at the brake peddle. test the switch and if it is faulty replace it.

Dec 13, 2008 | 2004 Kia Amanti

1 Answer

Cruise control does not work


Replace the Brake light control switch located in front of the brake peddle under the dash this also turns the cruise off when braking. While driving put your foot behind the brake peddle and pull back toward you while doing this try your cruise if it works there are three possible causes or a combination of all three. Brake control Switch, Loose or sloppy brake pedal not activating the Brake switch properly or week brake pedal return spring. Good Luck.

Jul 26, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
2003 Nissan Pathfinder Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...