Question about 2006 Chrysler Town & Country

1 Answer

My check engine light came on 42000 on the nose it says not to drive too long oil ok temp ok tranny ok now what please help thank you

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 14,036 Answers

TAKE IT TO ADVANCE AUTO OR AUTO ZONE TO SCAN IT .TO TELL YOU YOUR CHECK ENGINE LIGHT CODE.

Posted on Jul 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Check engine light came on today with AT oil temp and cruise control light too. The code I got was P0700 and P1710. Tranny shifts good no knocking or sound from tranny. Trying figure out how to fix this...


You will get your solution and all info on service info, repair info, parts info, wiring/electrical/fuse diagrams,
error/fault codes, torque specs, PCV,
owner's/service/repair/parts/maintenance manuals etc everything
this website www.reliable-store.com
it's a very good website for vehicle problems even as old as 1991 ford..

Feb 27, 2018 | Cars & Trucks

1 Answer

Transmission temp and over drive off light coming on


check the oil level first
too low and it will be low on pressure and overheat
too much and it will froth up and give the same indications
run the fault codes to check for sensor , servo or solenoid faults

Jul 15, 2017 | Cars & Trucks

2 Answers

How do you check the transmission fluid


On a 2000 Rodeo there is no dip stick, you have to warm the rodeo to normal temp then remove the drain plug on the transmission if fluid comes out it is ok if not you have to pump some into it with a oil can or some other pump I have one it sucks !

Apr 29, 2010 | 2000 Isuzu Rodeo

1 Answer

2001 ford escape.. oil light comes on when at a stop and in drive. when i give it the gas the light turns off. i checked my oil,brake,coolant and tranny fliuds and are all fine????? no funny sounds????


this light is indicating your engine has low oil pressure sensed at idle, have the oil pressure checked with a special mechanical oil gauge, if the oil pressure checks ok then just replace the oil pressure sending unit, do this ASAP, if u do really have low pressure u can damage the engine bearings, a very expensive fix.

Mar 19, 2010 | 2001 Ford Escape

1 Answer

Hi ford ka seem to lose power a couple of days ago seemed to be revvin badly now car broken down still fires up ok n goes into gear but just revs there in no drive smells like cluch but also a fair bit off...


Could be the crank oil seal, behind the flywheel, leaking oil onto the clutch assembly. Check oil level and look under the engine for oil droplets on the engine/gearbox joint or the underpan and crossmembers.

Jul 26, 2009 | Ford Focus Cars & Trucks

1 Answer

Check engine light tranny temp light, and o/d light


where the transmission and transfer case meet there is a weep hole,check for leakage out that hole...if it shows a leak you probably have a rear transmission seal leaking. if there is any sealer around where they meet someone tried to stop the leak without properly repairing it.

Dec 19, 2008 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

2001 dodge 1500 4x4


did you drain the fluid, it may have lots of metal and be really gummed up causing it to over heat and burn off. Aside from that the most commonly overlooked "check engine" proplem is the O2 sensors, there should be 2 of them

Dec 19, 2008 | 2001 Dodge Ram 1500 Truck 2WD

3 Answers

Tranny problem


over heated

Jun 27, 2008 | 1993 Saab 900

Not finding what you are looking for?
2006 Chrysler Town & Country Logo

Related Topics:

203 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

78936 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...