SOURCE: WOULD YOU KNOW THE TORQUE SETTINGS FOR MAIN
Mains Stage 1 83nm
Mains Stage 2 167nm
Big ends Stage 1 29nm
Big ends Stage 2 45 - 60 degrees
Hope this helps
SOURCE: cylinder head torque settings for a toyota 1493cc
If you have a vehicle application for the motor you can get a Haynes or Chilton manual from your local auto parts store. They usual run around $30.
SOURCE: whats the torque setting for big end bearing bolt
hi big end bearings are two stage, 25nm leave ten mins, then 49nm cylinder head bolts three stages 20nm leave ten mins, 40nm leave ten mins then 60nm check after 5,000miles hope this helps
SOURCE: i need to know the torque settings for 850cc reliant robin
go to
http://mankymonkeymotors.co.uk/Trikespageimages/relianttorquesettings.html
a target="_new" href="http://www.leafletflyers.co.uk/">Leaflet Distribution in Croydon</a>, Leaflet Distribution in Balham, <a target="_new" href="http://leafletflyers.co.uk/Leaflet-Distribution-Streatham.htm">Leaflet Distribution Streatham</a>.
56 views
Usually answered in minutes!
×