Question about 1991 Chevrolet Cavalier

1 Answer

When I put my foot on the gas pedal I do not get the proper RPM's

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 103 Answers

Sounds like you may have a blocked or partially blocked catalitic convertor

Posted on Jul 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1989 will not idle, have to keep foot on the gas pedal


It,s either not getting enough gas or not enough air. Check has and air filters.

Dec 09, 2014 | 1989 Cadillac Sedan DeVille

1 Answer

Rpm does not drop below 1000


No,only on carburated engines it,idles down to the set point,on yours,it's fuel injected,pushing gas pedal won't kick idle down,should go down after a certain amount of time,does it automatically,If you start and drive a 5 mile ride and stop at a stop sign,it should idle at it's set point if there's no engine problems,which may be.5 to .7 on your tac.When you normally first start,it will idle between 1000 to 1200 rpm's,don't push on gas,let idle say 15 seconds,put in drive and go.

Jan 13, 2013 | 2005 Chrysler Sebring Conv

1 Answer

My 1998 dodge caravan won't stay running. starts up but shuts down instantantly or when i take my foot off the gas pedal,


ok i have a 1998 durango with the 5.2L 318 engine. had trouble with a bad cell in my battery. I went out bought an optima red top battery for it 800cca. put it in and had same trouble. No start without putting foot on gas. wouldn't stay running without holding foot on gas. CPU has to relearn it's programming once you unplug it for long periods of time. mine was without power for about 2-3 weeks till i got new battery. Start with this.. first check under air filter make sure a squirrel hasn't made a mess under your air filter and it's clogging the air intake. Then pull off the lid to your injector cover ( the screw down lid coming from the air box ( with air filter in it) to "carb") make sure all your cables move freely. put that all back together and close hood. Start truck with foot slightly on gas pedal to get started. keep it at about 1k to 1500 rpm for about 1-2 minutes. Rev motor to about 2500rpm and let it die out if it will. Get out lock doors with key fob if you have it. if not make sure to lock doors. ( trust me it worked for me) let sit for 5 minutes. come back out and unlock door and relock door 3 times with fob ( if you have it ) or key if you don't have a fob. Then unlock it with the key and enter vehicle. Start truck as before and keep it around 1k to 1500 rpm again for about 30 seconds rev it up and should keep running. Mine did. I think the iac was stuck from sitting and has now since loosened up.
Good luck hope ti works for you.

Jun 05, 2012 | 1998 Dodge Caravan

1 Answer

We just put an alternator and a new battery on my Suzuki XL7 this past weekend. The RPM output is now low and when I drive it and take my foot off the gas pedal it shuts off. This did not happen before the...


adjust the throttle body screws is them screws where the two cables are by turning them you can bring up your rpm them cables are connected to the gas pedal

Feb 21, 2011 | 2005 Suzuki XL-7

1 Answer

Car will not start without pressing gas pedal to keep idle speed up. If I keep idle at 900 RPM or higher it runs as long as foot is on gas pedal. It then stalls out when I take foot off gas pedal. No...


Have the idle bypass valve checked, also called idle air control valve.
If that valve is stuck in the closed position, it's not allowing the fuel to bypass the throttle plate to keep it idling, resulting in stalling, but will keep engine running if the pedal is pushed down.

May 14, 2010 | 2000 Toyota Camry Solara

1 Answer

1997 f150 truck starts but doesnt stay running, only if you


sounds like either fuel pump weak or fuel filter plugged

Dec 06, 2009 | 1997 Ford F150 Regular Cab

1 Answer

1992 16V - idles fine, drives fine. Only when foot of the gas jer


idle air speed control valve(iac),too low idle or driveline problem like play in the drive shafts. if you put it in park and give it to say2500 rpm and let go of the throttle,does it return to 900rpm?if it dips down to 5 or 600 then to 900 the iac is bad.

Jul 13, 2009 | 1992 Volkswagen GTI

2 Answers

2002 toyota camry dies when I take my foot off the gas pedal


The ignition is too low (i,e, rpm). Increase it.

Mar 18, 2009 | 2002 Toyota Camry

Not finding what you are looking for?
1991 Chevrolet Cavalier Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...