Start by checking and changing trans fluid. If it is squealing or grinding it could be the throw out bearing.if so you might as well get a kit and change the clutch. Could also be the slave cylinder.
SOURCE: 01 dodge 1500 4x4 Transfer case / transmission problem
check the rear differential as well as the transfer case...you may have broken something in both of them...i have seen it happen...since 4low uses a different gear it is possible for it to move in low and not 4 high
SOURCE: 99 s10 4x4 automatic transmission was shifting
replace the transmission sounds like it is bad.
SOURCE: My 2001 Chevy Blazer ZR2
have a trans shop check the linkages/sensor should be cheap unless linkage is damaged from 4wheelin
Good Luck
SOURCE: The four wheel drive quit working while driving in
Your truck should have a solenoid attached to the front axel (more so to the right side). Unplug the solenoid and probe the harness. It should be two wires if not tell me. But it should have twelve volts on one and ground on the other (with the 4wd in-gauged) If that is fine remove the solenoid and see if it actuates when put it into 2wd and 4wd. If that checks out then the problem is either somewhere inside the front axel or maybe the transfer case. But the way you described it I would start with the front axel.
SOURCE: While driving, four wheel drive quit working. It
Check the fuse for the four wheel drive before taking another step,it is electrically engage,hope that help you and clear your mind
31 views
Usually answered in minutes!
×