Question about 2003 Kia Sedona

1 Answer

I have the same problem

My van stalls while driving - sometimesit wont start and then after a minute it will and be fine- it threw a code one time saying it was the mass air fow sensor- we got new one and still have same problem- my neighbor ran code again it says low voltage- dont know what to do

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 70 Answers

Check your voltage regulator, Where if faulty / going bad but not totally gone yet.

When first starting and driving initially it can operate fine and distribute current properly and give no indication of a problem.

But after periods of operational flow regulation can start showing faults when heated and loads of regulating power to various circuits take it to task.

Posted on Jul 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My van won't start after driving a short distance, it will start again after 3 to 5 minutes but then will act like it's going to stall while I'm driving. What's wrong?


Hi Greg, I'm AL the owner of Big As Auto Repair in St Charles Mo

Greg, I read your complete message, but nowhere did I see that you replaced the Cam Sensor. The EGR will cause it to stall at stops but usually will not prevent it from restarting. I would try replacing the Cam Sensor before anything else. If you should need further assistance go to my website by clicking here: Auto Repair

Mar 19, 2015 | 1997 Dodge Caravan

1 Answer

My van lost power then died and wont start, the vehicle was driving fine then it just lost power...it was idling around 2-300rpm then completly stalled, when i try to start it it just cranks over


Have you had the electronic engine control system scanned/tested for fault codes? it will need to be scanned to obtain the fault codes, this testing is key to finding out what the problem may be that is causing the engine to stall. The fault code test can be done free of charge by any Autozone auto parts store, Aamco transmission or Kragen/Oriley auto parts store. Ask for a "OBD2" (on board diagnostics generation 2) fault code test.

Nov 01, 2011 | 1999 Pontiac Montana

1 Answer

My van stalls when i let off the gas?`


i have replaced most things on the van due to same issue.. im going to do the map sensor next.. good luck.. if questions, email me at meduso99@yahoo.com

Nov 09, 2009 | 1994 Chrysler Town & Country

1 Answer

02 Chevy Blazerstalling problem after about 45 minutes of driving


vacuum leak? or try the fuel pressure regulator my started stalling then got to where it wouldn't crank. changed the fuel pressure regulator and it ran as if it was brand new

Oct 09, 2009 | 2002 Chevrolet Blazer

1 Answer

Stalls just after idling for more than 3 minutes


I had the same problem. you have to either keep replacing the filter until the line has cleaned out or blow the filter out with an air hose. Tedious but cheap.

Aug 01, 2009 | 1993 Dodge Caravan

1 Answer

2001 dodge grand caravan stalls


Check the sensors on the throttle body. There is a sensor that controls air to fuel ratio. If that sensor is bad then the car will run and then stall out while in drive. I had the same problem when it was cold outside last winter. If you dont want to dish out the money without knowing if it is that part at fault or not then start the van pop the hood and located the throttle body. Place your hand on the sensors and give them a little shake and then make sure they are plugged in all the way. You could also turn the van off and unhook the sensor clean the connectors and plug it back in. That should do the trick and if it doesnt stall anymore then I would replace those sensors if I was you. One more thing. If your giving the sensors a tug while the car is running and you hear it going to stall you could located the gas pedal cable and give it a rev or two by hand so it doesnt stall out and turn off. By the way. You van isnt over heating at all is it?

Feb 11, 2009 | 1994 Dodge Caravan

1 Answer

1997 dodge caravan p 1495 code


if I am not mistaken that is the code for the engine temp sensor, it kind of works as a choke, it tell the computer the ngine temp so it can lean out the fuel mix. I think the code says engine is taking too long to warm up. A faulty sensor will read -40 C all the time

Nov 07, 2008 | 1997 Dodge Caravan

2 Answers

1997 Voyager Van Stalls then Starts


most of times stalling problems are related with crankshaft sensors have your crank sensor replace and see if this will take care of your problem

Jun 03, 2008 | 1995 Dodge Caravan

Not finding what you are looking for?
2003 Kia Sedona Logo

Related Topics:

261 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...