Question about Cars & Trucks

1 Answer

How do I open the part 3 - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 9,742 Answers

Not enough information. Please elaborate.

Posted on Aug 13, 2017

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 36" storm door. Instructions call for a 35 7/8" - 36" opening width (between vertical brick molding trim). Currently i have about 35 3/4-35 13/16". Suggestions please


You just need a 1/8" piece to add to the opening... you can screw it to the opening...measure the width that is necessary and the height (minus 6" - 3" on each end)....PREDILL the 1/8 piece with a 1/16" drill bit and use #1 size screws about 3/4" long. .This will take up the excess space..

Jul 06, 2017 | Cars & Trucks

1 Answer

I want to van camp in my Transit 2014 - with the doors open -


Hi Jene, there should be a 3 way switch above the rear view mirror to control the lights. The 3 positions are 1.all the way over to one side = Off, 2 in the centre position = Door Open & 3. all the way over to the other side = Always On. There may be a similar switch at the centre dome light. Also have you waited for the light to go out? sometimes these lights are on a time delay.
Trust this helps, regards Alan

Apr 12, 2015 | 2014 Ford Transit Connect

1 Answer

2-3 shift solenoid circuit


P0758 Chevrolet P0758 Chevrolet - 2-3 Shift Solenoid Circuit Electrical
Possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Faulty 2-3 Shift Solenoid Valve
- 2-3 Shift Solenoid Valve harness or connectors
- 2-3 Shift Solenoid Valve circuit is open or shorted
What does this mean? When is the code detected?
When the Powertrain Control Module (PCM) detects a continuous open, short to ground or short to power in the 2-3 Shift Solenoid (SS) valve circuit, then DTC P0758 sets.
Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Transmission will not shift gears
P0758 Chevrolet Description
The 2-3 Shift Solenoid (SS) valve controls the fluid flow acting on the 2-3 shift valves. The 2-3 SS valve is a normally-open exhaust valve that is used with the 1-2 SS valve in order to allow four different shifting combinations. The solenoid attaches to the control valve body within the transmission. The Powertrain Control Module (PCM) controls the solenoid by providing the ground path.

Read more: http://engine-codes.com/p0758_chevrolet.html#ixzz3kcwzXFmK

Jul 14, 2014 | 2000 Chevrolet Silverado 1500

1 Answer

I have a 2002 nissan sentra se r spec v and the dome light does not turn on when u open the doors but I does when u switch to on mode help please


dome light switches normally 3 position switches 1 position is light on door open 2 position is no light door open and no light in car 3 position is light on in car but not with door open.

Jun 01, 2013 | Cars & Trucks

1 Answer

My electric sun roof is open 3-4 inches and will not open or shut although increases to open a little each time i use car


plastic lining on runners tend to crack and lift causing roof to stick. can remove plastic but roof will rattle when closed. to close manually, open small cover on roof lining in front of sunroof and crank roof closed with an3mm allen key.

May 12, 2010 | 1994 Audi 100

2 Answers

I have a Nissan Frontier with accelerator & throttle problems. I have sensor codes p2122 & p2138. How do i fix this problem? Is it a self fix problem? HELP!


Throttle/Pedal Position Sensor/Switch "D" Circuit Low
P2122 - APP Sensor 1 Low Input

Probable Causes:
1 - Failed APP Sensor 1
2 - Open or short circuit condition
3 - Poor electrical connection

----------------------------

P2138 - APP Sensor Performance Condition Fault

Probable Causes:
1 - Failed APP Sensor
2 - Open or short circuit condition
3 - Poor electrical connection
I hope this helps you and thank you

Feb 14, 2010 | Nissan Frontier Cars & Trucks

1 Answer

3 nonddriver windowswont open; did open from remote key


pcm needs to be updated it has a brain fart

Sep 28, 2009 | 2005 Honda Accord

2 Answers

Power Door Light Stays on after battery was changed by a service department


follow this to reinitialize
1. Push the “MAIN” power switch to the “OFF” position.
The “MAIN” power switch is located on the instrument panel, left of the
steering column.
2. Confirm doors are closed, lights are OFF, and the key is out of the ignition.
3. Disconnect the negative (–) battery terminal and wait 60 seconds.
4. Reconnect the negative (–) battery terminal.
5. Push the “MAIN” power switch to the “ON” position and wait 3 seconds.
6. Push the “DOOR R” switch to open the right door and wait 3 seconds after the door
is completely opened.
7. Push the “DOOR R” switch to close the right door and wait 3 seconds after the door
is completely closed.
8. Push the “DOOR R” switch to open the right door and wait 3 seconds after the door
is completely opened.
9. Push the “DOOR R” switch to close the right door and wait 3 seconds after the door
is completely closed.
10. Push the “DOOR L” switch to open the left door and wait 3 seconds after the door is
completely opened.
11. Push the “DOOR L” switch to close the left door and wait 3 seconds after the door is
completely closed.
12. Push the “DOOR L” switch to open the left door and wait 3 seconds after the door is
completely opened.
13. Push the “DOOR L” switch to close the left door and wait for the door to
completely close.
With ignition in the “ON” position and both power sliding doors in the fully closed
position, the “PWR DOOR” indicator on the dash should NOT illuminate.
14. Confirm proper operation of both doors using the dash, B-pillar switches, and the
transmitter button

Aug 12, 2009 | 2001 Toyota Sienna

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...