Question about Cars & Trucks

Open Question

How do I change the rear blower motor on a 2008 Chevy express van?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: blower motor on 1999 chevy express van works only

Just to add to the previous post. The blower motor resistor is under the hood on the passenger side behind the battery.

Posted on Jun 07, 2009

  • 118 Answers

SOURCE: changed radio in a 2008 chevy express van,now radio is locked

The codes for the radio are in the back of the owners manual.

Posted on Jul 27, 2009

  • 126 Answers

SOURCE: Where is the blower motor resistor located on a

most are on the heater case near the blower motor

Posted on Oct 11, 2009

BCAS1298
  • 3092 Answers

SOURCE: 2001 chevy express van 1500,

Inside the van, all the way to the rear, on the side, will have a nice looking panel over it, remove panel and you'll see blower motor, held on with about 6 small screw's.

Posted on Aug 05, 2010

duane_wong
  • 6826 Answers

SOURCE: How do you change the

Axle Shaft Bearing & Seal Removal & Installation To Remove:

  1. Raise and safely support the vehicle.
  2. Remove the axle shaft.
  3. If replacing only the seal, remove the seal using a suitable seal removal tool.
  4. If replacing the seal and bearing on the 8.6 inch axle, install the slide hammer and adapter behind the bearing and pull out the bearing and seal together.
  5. If replacing the rear axle shaft seal and the bearing on the 9.75 inch axle, install the J 29712 or equivalent bearing puller into the axle housing behind the axle bearing.
  6. Remove the axle shaft seal and the bearing by tightening the nut on the J 29712 bearing puller.
Use a slide hammer, bearing puller and adapter to remove the old axle bearing 88457g81.gif

To Install:
  1. Install the axle shaft bearing using a suitable size driver. Drive the bearing into the housing until the tool bottoms against the tube.
  2. Lubricate the seal lip and install the seal with a suitable seal driver. Make sure the seal is fully seated in the axle tube.
  3. Install the axle shaft.
  4. Fill the rear axle with the correct lubricant.
  5. Lower the vehicle.
prev.gif next.gif

Posted on Oct 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is blower motor relay located on a 2002 Chevy express van


.. The blower motor relay is an integral part of the blower motor resistor and cannot be serviced

Mar 03, 2015 | 2002 Chevrolet Express

1 Answer

Fan blower resistor


change the relay, its stuck in the contact positon

Dec 10, 2013 | Chevrolet Express Cars & Trucks

1 Answer

06 Chevy Express, Blower Randomly Comes On But Wont Work All The Time. Resistor?


It sounds like a bad contact in the blower switch. Change the switch!

Jan 22, 2013 | 2006 Chevrolet Express

1 Answer

2002 3500 chevy express van blower inop


fuse or blower motor not much else it could be

Aug 24, 2012 | 2002 Chevrolet Express

1 Answer

I have a 2007 Chevy Express 3500 Ext. - My rear air just stopped. A/c works as normal up front but no blower running in the rear. I have checked all the fuses, what I could find. What next?


the rear blower has its own motor in the back the rear blower motor may be bad or the wires going to it may be bad test for power going to blower motor if you have power in harness hooking to blower motor then blower motor may be at fault auto parts store sells the book on your vehicle its about 18 dollars if not lesser buy a test light trace down your problem if the fuse is good your rear blower motor will be in the back of your vehicle theres a cover that pulls air in back there take the cover of it off you will see your blower motor test wireing going to it for power theres also blower motor relays research it read and you will find the problem good luck

Feb 24, 2011 | 2007 Chevrolet Express Passenger

1 Answer

2001 chevy express van 1500, rear blower motor location


Inside the van, all the way to the rear, on the side, will have a nice looking panel over it, remove panel and you'll see blower motor, held on with about 6 small screw's.

Aug 05, 2010 | 1999 Chevrolet Express

1 Answer

2008 chevy express 2500 with a 6.0 crank sensor problems


check the alternator ouptut ,it shouldnt go above 15v ,

Aug 01, 2010 | 2008 Chevrolet Express

2 Answers

How to replace brake light in 2008 chevy express cargo van


You have to remove the upper applique to remove the tail lamp, it is the trim panel above the lamp. I think it is held in place by two nuts/bolts but not sure. You have to have the rear doors open to remove it

May 23, 2010 | 2008 Chevrolet Express

2 Answers

Blower motor on 1999 chevy express van works only on high position.


Just to add to the previous post. The blower motor resistor is under the hood on the passenger side behind the battery.

May 11, 2009 | 1999 Chevrolet Express

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...