Question about Cars & Trucks

Open Question

Finding blower motor resistor 97 dakota 5.2 l

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: locating heater blower motor resistor

the resistor is behind your glove box. open the box and push in the sides to release it and let it hang down...the resistor is right there. I didn't try to replace it, a friend did it, but the part was under $20.

Posted on Feb 01, 2009

  • 4 Answers

SOURCE: 2002 Chevy Impala Blower resistor location

It is on the passenger side, you have to remove the black plastic kick plate, below the glove box, to expose it (held in place with 2 latches and 1 push pin). The resistor is in front of the blower motor ( sandwiched between the motor housing and the firewall) it is tricky to get to, i think when i changed mine i didnt replace all the screws as they were difficult to remove and even harder to replace. Good Luck, Mike

Posted on Apr 20, 2009

emissionwiz
  • 75822 Answers

SOURCE: Where do I find the blower motor resistor on a kia optima 2006

under the dash on the passengers side

Posted on Jun 19, 2009

emissionwiz
  • 75822 Answers

SOURCE: where is the rear blower motor resistor on 2001 Dogde Carvan?

no diagrams avil on fixya, sorry, the blower resistor is right next to the blower motor in the air duct that cools it.

Posted on Oct 19, 2009

  • 2 Answers

SOURCE: 2005 Chevy Surban blower motor resistor

mine did the same thing. It was the gears breaking off in the resistor. However, the wiring harness and resistor melted inside of the dashboard AND DID NOT trigger the fuse... causing a safety issue. This was this past month. I notified GM and the National Highway Traffic Saftely Administration hotline located in the owners manual. They are not tracking this problem to see about safety recall. If you have this issue, you need to ntify them as well at their toll free number

Posted on Oct 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The a/c and heater fan does not work


Kerry, Check all fuses and relays, quite often it is the blower motor resistor. 3 rd link will show diagnosing fan. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Blower motor resistor 01 Dakota
http://www.thegatesofdawn.ca/wordpress/posts/2005/07/19/dakota-fan-problem/comment-page-6
Dakota Durango Blower Motor Resistor Troubleshooting Replace

May 26, 2016 | Dodge Dakota Cars & Trucks

2 Answers

A//c unit works only on high speed/


blower motor resistor...it cuts power to lower settings...easy fix usually under passenger side glovebox two screws and harness looks like a metal card with plastic bottom...

Jan 28, 2016 | 2004 Dodge Dakota

2 Answers

Where is the heater resistor on a 2005 dodge dakota? Behind glove box?


should be just above the blower motor. You will need to remove the glove box door to gain access.

Dec 12, 2015 | 2005 Dodge Dakota Club

1 Answer

I need to replace my blower motor resistor as my fan switch only works in 1 and 5. What is the easiest way to do this job. Thanks Trevor


It's not the blower motor that is bad, but rather the blower motor resistor. Next to the motor is the resistor and by replacing that the motor should work in all the speeds. This is a common problem on the 97-04 Grand Prix.

May 13, 2010 | 2000 Pontiac Grand Prix

2 Answers

Where is the blower motor resister located on on a 2005 dodge dakota V6 slt?


It should be mounted on the blower box,near the blower motor to keep it cool,it mounts on the out side,but actually goes inside the blower box,it has a multi wire connector to it.

May 11, 2010 | 2005 Dodge Dakota

1 Answer

Where can i find the blower motor resistor on a 97 mazda protege?


I think any parts store can get it for you.

But if you asking for location of the component , then it's a different story.
All b/m resistors(any car) located around blower motor or in the air duct after blower motor, they need to be vented all the time , otherwise they overheat and blow. Wires from motor are going to resistor , so if you trace the wires you'll find resistor.

May 05, 2010 | 1997 Mazda Protege

2 Answers

Hi ya, i just inquired about my blower motor, is the relay and switches and everything under the dash or under the hood,


In the Dodge Dakota the blower motor resistor is located under the hood, on the right side firewall.

Dodge Dakota Blower Motor Resistor Location:

b3bc94a.jpg

Dodge Dakota with a complaint of no blower operation. After unplugging the harness connector and removing the two screws, you could remove and examine the resistor coils for damage. The heat and subsequent rust damage are clearly visible in the picture below.

6f6f301.png

Apr 07, 2010 | Dodge Dakota Cars & Trucks

1 Answer

Blower motor resistor on '04 Dakota 4.7L V8. Second time this has happened, short out? Blower only works on lower levels, not on high.


Has the blower motor been replaced as well. If you put one resistor on, and it goes bad again, the motor is pulling too many amps and burning it up.

Jun 29, 2009 | 2004 Dodge Dakota

1 Answer

Fan switch works on only one speed


  1. Disconnect and isolate the battery negative cable.
  2. From the passenger foot well area, remove the two hex screws used to secure the blower motor resistor.
  3. Unplug the front blower motor resistor from the wire harness connector.
  4. Pull the front blower motor resistor and its wire harness out of the plenum panel and through the cowl plenum access hole far enough to access the wire harness connector.
  5. Remove the front blower motor resistor from the cowl plenum.
INSTALLATION
  1. Plug the blower motor resistor into the wire harness connector.
  2. Install the blower motor resistor to the cowl plenum panel by feeding the resistor and wire harness back through the cowl plenum access hole.
  3. Install and tighten the two screws that secure the resistor to the HVAC unit Tighten the screws to 2.2 Nm (20 in. lbs.) .
  4. Connect the battery negative cable

May 27, 2009 | 2001 Dodge Dakota

1 Answer

Heater won't turn on


replace your blower motor resistor its about 20 bucks and i could only find one at the dealer i had the same problem 4 months ago if that doesnt work your next option is the blower motor but im 90% sure its the resistor 04 dodges have alot of problems with that resistor burning out it is located on the passenger side beside the blower motor two bolts holding it in it will be a rectangle shaped piece of plastic just un clip it and clip the new 1 in

Mar 24, 2009 | 2004 Dodge Dakota

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...