Question about Cars & Trucks

Open Question

Grapple on a 1997 873 grappple pistons wont work keeps blowing fuse but bucket tilts and goes up and down its a bobcat and repair shop put in new selonoids on direction control valve and did nothing

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

hi99ins
  • 123 Answers

SOURCE: tilt steering doesnt work blows fuses

The wire that supplies a live to your radio, runs from ignition down the steering column. You probably have a chafed wire along that loom, as you tilt the steering, the wire grounds so the accessories fuse/radio fuse blows. Remove the panel under the steering column and/or the shroud around the column and examine the wiring.

Posted on Jan 10, 2009

  • 60 Answers

SOURCE: fuse keeps blowing and gages stop to work the car will run hot intill new fuse is back in

you got a grounded wire. check the wiring in the back of the radio if its custom radio i can almost gaurentee thats what it is. however electrical aint my best area. lemme know if i helpd any.

Posted on Apr 24, 2009

  • 85 Answers

SOURCE: truck wont start keeps blowing the ecm batt fuse

You have a short (bear wire) somewhere. Trace the wire and find it.
Have a great evening

Posted on May 01, 2009

  • 412 Answers

SOURCE: radio fuse keeps blowing

make sure nothing in cig lighter socket..coins,etc..if nothing present,unplug cig lighter socket and replace fuse..if fuse doesn't blow,it's the socket causing fault..if it does,unplug radio,plug cig lighter back in and replace fuse..if fuse doesn't blow,radio is cause of fault..if it does,then ther is short in wiring

Posted on May 19, 2009

  • 3 Answers

SOURCE: I have a 2002 Ford F150. Fuse 15 (5 Amp) keeps blowing.

replace nuetral safty switch for gear shifter and check window relays

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Signal fuse keeps blowing


Does the fuse blow on both left and right sides,or just blows randomly or as soon as you put the new fuse in?
Does it have tilt steering?I would check the wiring in the steering column to start.

May 18, 2017 | Cars & Trucks

2 Answers

My 2004 ford explorer keeps blowing the ignition fuse also i noticed that my windshield wipers also stopped working


You have a short to ground on that circuit ,the only way to find it is to find a wiring diagram an see what all gets power from that fuse .Then isolate each circuit until the fuse doesn't blow any more . Go to youtube an check out some videos on finding a short on automotive wiring . Also I suggest you check out some videos on basic automotive electrical trouble shooting . Finding an fix automotive electrical shorts is best left to a automotive electrical repair shop !

Jan 14, 2016 | 2004 Ford Explorer

1 Answer

How do I replace hydraulic line from pump to right arm on my 96 753 bobcat


to replace hoses on hydraulic equipment you have to have all the parts in the relaxed position clean the area of the connections so that dirt will not get into the system.

that is the bucket on the ground, allowed to tilt forward

nothing can be held under hydraulic pressure

the engine should be shut off

use spanners to undo hose fittings (no hands)

ensure a safe work procedure and wear rubber gloves , eye ware ,face shield and keep hands away from connections ---oil under pressure can penetrate the skin and cause immediate death ---

once you have the hose disconnected replace it with a new hose

after fitting the new hose and tightening the fittings ,start the engine and cycle the hydraulics as this eliminates the air in the system

Jul 27, 2015 | Cars & Trucks

1 Answer

No gauge lights in my 97 sunfire, fuse keeps blowing. The fuse keeps blowing that controls the gauge lights so I put a 15a in it and now they will not work at all please help me


You probably have a wiring short, and unless you know your way around under the dash, you'd do better taking it to a repair shop that has an employee very knowledgeable specifically in electronic gauge troubleshooting and repair. Save yoursef the time and grief.

Jan 22, 2013 | Cars & Trucks

1 Answer

Rad/hvac fuse keep blowing


Your Blower motor is going bad drawing to much amperage if you keep replaceing the fuse you can melt the connector where it plugs into the motor and make it harder to repair because now you have to repiar the wiring. You should also replace the Blower motor resistor when you replace the Blower motor . They work together and somtimes when the blower motor goes bad it damages the resistor internally and fails right after you put the new motor in .

Aug 05, 2012 | 1997 Jeep Grand Cherokee

2 Answers

How do I diagnose a recurring blown fuse in a gmc acadia 2009 50 v causes car to get stuck in park, no power windows, no lights, no temperature controls, power locks


You buy the GM factory manual and then use the wiring diagrams to track down the systems the fuse supplies power to, and one by one you go through each circuit until you find the short circuit. There is no cut and dry way that works every time to find this type of an automotive electrical problem, I have been doing auto electric for 25 years and seldom does the same repair fix more than one car or truck. You can also rent the manuals for download at this site for about $40 per year, a great deal. www.alldatadiy.com

Jan 31, 2012 | GMC Acadia Cars & Trucks

1 Answer

I have a 2004 Chrysler Sebring Convertible and for some reason I keep blowing a fuse. Or I have a short circuit some where that is blowing the fuse. Monday morning it wouldn't start. Tuesday at the...


To find out what circuit is drawing down the battery, Remove all the fuses making sure you mark where they come from. Disconnect the positive lead on the battery. Put one fuse in at a time. Then after each fuse put the positive cable to the post. If it sparks, you have found the draw. That will at lest identify the circuit. Then you can look into that circuit or bring it to the repair shop knowing what is drawing it down.

Sep 27, 2011 | 2004 Chrysler Sebring

1 Answer

My dome lights keep blowing fuses. Also, the


on the dome light you could have a short in the wire that gos to the if you know how to take the light out and check the wireing i would do that.. check the fuses for lighter if they are good then could be that something has shorted them out!!!!! maybe same fuse goes with dome lights

May 13, 2010 | Chevrolet Malibu Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...