Question about 2008 Dodge Avenger

Open Question

Flashing red light on 2008 dodge avenger and car won't start, get nothing when i turn key.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 6 Answers

SOURCE: dodge avenger 2008

It depends on who you go to and if you want it done right. I went to the Dealership and had them put front brakes on my 2008 Dodge Avenger and it has been in the shop every 2-4 months since then for front brakes. They replaced the entire front brake system and my 08 Avenger is still eating brakes. I finally took it to a friend who owns a auto repair shop he replace the rotors which are total about 115.00 for each from AutoZone and replaced the brake pads for 50.00 so it cost me just parts 155.00 and my Avenger is running smoothly since haven't had problems with the brakes since. Go to Midas and let them change it for roughly 89.00 avoid the dealership at all cost they can run 200.00-500.00 depending on if it is just the brakes pads or if it is the rotors and pads.

Posted on Jun 02, 2009

Ad
  • 1071 Answers

SOURCE: 2008 dodge avenger. Will not move out of park.

ther is an electric solenoid in the shifter the fuse may have blown but if you have ever spilled anything sweet ,soda juice etc it will get sticky and gum up not letting it operate as designed check fuses first, if fuse is good then go to solenoid

Posted on Jul 21, 2009

  • 454 Answers

SOURCE: 2008 dodge avenger with a flashing lightning bolt

Sounds like electrical problem. You are under warranty, take it to dealer for diagnosis / repair.

Posted on Nov 10, 2009

  • 63 Answers

SOURCE: 2008 Dodge Avenger check engine light

Not sure if this will work for you but worth a shot. I own a 2005 dodge neon. I know the ecu's are different but maybe dodge was smart and made all the cars this way. Insert you key into ignition. Turn key forward until you are at the last position right before the car starts to crank over. Repeat this for a total of three times then on your digital odometer display, you will see a set of numbers displayed. this will be your code for the malfanction(s) that set your check engine light. Like I said, it might not work on your car but give it a shot. If not, rent an obdII scanner and get your codes. Then you know where to start looking to fix your problem.

Posted on Dec 17, 2009

emissionwiz
  • 76132 Answers

SOURCE: 2006 AVALON KEY IGNITION RED LIGHT FLASHING

Is this a new problem? I think it may be normal.

Posted on Jun 22, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Flashing red light on 2008 dodge avenger and car does nothing when i turn the key


Security system does not recognize the key. Try locking the car and then unlocking with the key in the driver's door lock. If that doesn't work, try what these guys say in the link below.
Anti theft activated

Aug 12, 2017 | Dodge Cars & Trucks

1 Answer

2008 Dodge Avenger. The check engine light was on. Had it reset at Autozone. They said it was the Power Control Module Code. I drove the vehicle for a while. One day acted like a dead battery. When I


well it seams that Power disconnected, I mean do you have any security device kind of remote security device , it have power shut down from there for security reasons... so check it from there ...
best of luck if you have any further problem feel free to mail me .....my shahrukhali@hotnail.com

Nov 22, 2013 | 2008 Dodge Avenger

1 Answer

Electronic throttle control indicator light


Here's the part,it's located near thermostat housing,easy to remove.

Dec 30, 2012 | 2008 Dodge Avenger

1 Answer

2008 avenger engine light won't go off after replacing serpentine belt


Belt has nothing to do with any OBD Code Check Lights,
it is just an accy drive belt

Check for codes & diagnose what ever area they take you to

Jul 18, 2012 | 2008 Dodge Avenger

1 Answer

How do you shut change oil display after changing oil on dodge avenger


turn key to on position but don't start, then pump gas pedal slowly 3 times and light should go off and stay off just did it on my 08 avenger

Mar 18, 2010 | 2008 Dodge Avenger

1 Answer

2008 Dodge Avenger check engine light


Not sure if this will work for you but worth a shot. I own a 2005 dodge neon. I know the ecu's are different but maybe dodge was smart and made all the cars this way. Insert you key into ignition. Turn key forward until you are at the last position right before the car starts to crank over. Repeat this for a total of three times then on your digital odometer display, you will see a set of numbers displayed. this will be your code for the malfanction(s) that set your check engine light. Like I said, it might not work on your car but give it a shot. If not, rent an obdII scanner and get your codes. Then you know where to start looking to fix your problem.

Dec 17, 2009 | 2008 Dodge Avenger

2 Answers

Reset oil change for a 2008 dodge aveneger


To reset your maintenance reminder system (even if the light hasn’t come on yet), you’ll need to turn your key to on (but don’t start!) and make sure your odometer is on TRIP A. Then key off. Press and hold the Odometer/Trip button. While holding down on the button, key the ignition to on (Don’t start the engine!) The display panel will count down from “------“ to “-“Continue pressing the button until the Trip A is displayed. After this step, you are done.

Oct 21, 2009 | 2008 Dodge Avenger

1 Answer

How do I get the "Change Oil " light to go off after change .


Turn key to the run posistion and pump the gas peadle 3 times under 5 seconds.

Jul 18, 2009 | 2008 Dodge Avenger

3 Answers

2008 Dodge Avenger electrical problem


i also have a 2008 avenger rt.its o good thing your car is under warranty it is must likely the turn multifunction switch.which controls a lot of stuff light turn signals brights. i hope this helped please rate this answer thanks.

Feb 01, 2009 | 2008 Dodge Avenger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...