Question about Cars & Trucks

Open Question

Can I replace my 2003 monte carlo 3400 with a 2004 3400?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 2001 monte carlo

do you have spark if you have no spark the crank sensor is bad.do you have fuel presure now. if not check the fuses. nead more info

Posted on Nov 23, 2008

  • 1 Answer

SOURCE: loss of power...2003 chevy monte carlo

catalitic converter if car is under 80,000 miles or 8 yrs dealer must replace free i had same problem

Posted on Jan 10, 2009

  • 218 Answers

SOURCE: Cabin air filter in my 2001 Monte Carlo

OPEN THE HOOD.ON THE PASSENGER SIDE BELOW THE WIPER IS PANEL TO BE REMOVED.IT IS IN THERE

Posted on May 04, 2009

  • 14 Answers

SOURCE: 2003 Monte Carlo SS Hesitates and Dies after running for awhile

The ck engine light should not be ignored, what sensor was shown to be bad ? Have it scanned again and replace the sensor that is bad if it still runs rough you might want to consider a tune up. Plugs, wires, fuel and air filter's and clean the throttle body with some gumout. It could also be the IAC motor Idle Air Control. Good Luck

Posted on Jun 23, 2009

  • 141 Answers

SOURCE: remove the power steering pump pulley on a 2003 monte carlo

you can either remove the steering pump to gain access,if there is no holes in PS pump pulley,you can rent a pulley puller....can be a ***** to get in and use them though....I will drill a hole in it for next time whenever I replace a pump on cars without ....

Posted on Aug 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My monte carlo 2003 does not have taillights everything works except taillights and dash lights


2 things to look at is the directional switch and or brake light switch on the brake pedel. my 1999 monte had the same thing and I replaced thedirectional switch and it was fixed

Oct 29, 2012 | 2003 Chevrolet Monte Carlo

1 Answer

How do i go about putting a 12 volt toggle switch (kill switch) in my 2003 monte carlo


2003 Monte Carlo comes equipped from the factory with an ignition switch and an antitheft system. Why do you want to install a "Kill Switch"?

Jan 23, 2011 | 2003 Chevrolet Monte Carlo

1 Answer

How do I adjust the door on my 2003 Monte Carlo SS? It's hanging a little too low and is not closing right.


There is no adjustments on the 2003 Monte Carlo. The bushings in the hinges are worn and the whole hinge will need to be replaced.

Best is to replace the upper and lower hinge. It takes just under an hour with a helping hands to remove the both hinges, but replace them one at a time.

Thank you for using Fixya and be safe.

Dec 31, 2010 | 2003 Chevrolet Monte Carlo

1 Answer

2003 monte carlo


yes it is. it is meant to inform you that your loosing traction.

Apr 25, 2010 | 2003 Chevrolet Monte Carlo

1 Answer

2003 Chevy monte carlo 3.4L, need the torque


Check Autozone.com. There repair section should have the torque specs and order of tightening.

Mar 06, 2010 | 2003 Chevrolet Monte Carlo

1 Answer

2003 Monte Carlo belt diagram


usually there is a diagram under the hood,have a computor? go to ask.com!

Dec 31, 2009 | 2003 Chevrolet Monte Carlo

1 Answer

My 2003 monte carlo wont start after maybe 30 mins of driving


please be more specific --- will not start after ???

Dec 11, 2009 | 2003 Chevrolet Monte Carlo

1 Answer

I have 2003 monte carlo dashboard warning


your on-board computer won't know it's replaced unless you activate the highbeams to complete the circuit,

Aug 14, 2009 | 2003 Chevrolet Monte Carlo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...