Question about Cars & Trucks

Open Question

My ML320 occasionally will not kick down. It is happening increasingly now. Coming up to 197000 Kl. When it happens,I can c0hange up and down using the steering wheel paddles but the car wont rev out

Happening at least once a day out of 3-4 shortish journeyd -10 -40 kls.No lights or messages. Had it to transmission shop ' they changed the oil and ran diagnostics -no issues?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2002 Jeep Liberty oil pressure light comes on in cold

Chrysler mounted the oil sensing unit on these motors directly above the oil filter. It is very easy to accidently hook the sensing unit with the oil filter wrench and crack or break it. For anyone whose oil light problem developed right after an oil change, this may be the problem. To change the unit, pry up the plastic retaining clip with a screw driver and unplug the wire harness. If the plastic part of the sensor is broken, (or if you break it to facilitate easy removal), you can remove the sensor with a 27mm socket. Once you have removed it, use a piece of CLEAN pipe cleaner to insure the hole isn't plugged with sludge which could also cause the oil light to come on. Screw in the new unit finger tight, then snug up with a WRENCH. You cannot use the socket to tighten it as it would damage the plastic part of the new sensor. Plug the wire harness back on, then start the engine to make sure it doesn't leak oil around the new unit.

Posted on Jan 13, 2009

Ad
  • 55 Answers

SOURCE: CAR WON'T START. NOT BATTERY. CHANGED FUSE AND RAN

There are way too many possibilities for us to try to start to diagnose your car. . Id check all fuses and fusible links if I were you., Body shops often jump start cars that are in their shops for long periods of time, Jump starting can cause alot of issues.

Posted on Aug 25, 2009

  • 104 Answers

SOURCE: change oil light came on, car had oil change 1000

get oil pressure test done and check for codes in PCM

Posted on Oct 20, 2009

ourhowse
  • 2007 Answers

SOURCE: Car won't move

It would appear that your CV joints are worn out completely, and you are going to have to replace them, or the whole half-shaft. When you hear those funny noises, that is your car talking to you... the only way it can, and you have to fix those noises ASAP.

Posted on Dec 27, 2009

  • 98 Answers

SOURCE: My car randomly shuts off while driving. I could

Wiggle the keys around when the car is running and see if you can repeat the problem. If so replace the ignition switch.

Posted on Jan 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I turn on my heat or air, nothing happens. There is a slight hint of heat or AC coming out of the vents when I have it set at 4. It will occasionally work, if I hit a bump just right, and it kicks...


If I'm reading this correctly- your blower isnt working? the fan doesn't blow? If the blower comes on over hard bumps, probably the blower motor is bad. More common is blower resistor, but try to find motor & bang on it while switched on...if it comes on, the motor is bad.

Sep 15, 2013 | 2004 Dodge Stratus

1 Answer

I have a 1994 toyota camry 4 cyl. When I first start the car it idols rough and when I start to accelerate it is hesitant and buck a little. Once the car is warm it accelerates just fine but when on the...


scan the computer with a computer scanner just to see what it says. check your intake, I am thinking your mass air flow sensor is no good. it happened to my car where the rpm increases and decreases when the car is idle. Or it can be the IAC valve.

Jun 09, 2011 | 1994 Toyota Camry

1 Answer

1996 CAD GOES TO THE ECON MODE I CANNOT GET THE AIR CONDITION MODE TO DISPLAY. WHAT COULD BE THE PROBLEM?


Hello Bluebear.

When this happens on the Cadillacs of that year it is low or empty on refrigerant or the low pressure cycling switch has a problem.
The reason it happens is to prevent the compressor from coming on to protect it.
Without refrigerant in the system it can't get properly lubricated and will burn out.
I would recommend the system be checked by a professional.
You will just be wasting your money on kits at auto supply stores.
If you would like further advise on your Cadillac's AC, please ask me in comments.

Thank you for using FixYA.
KL

Mar 07, 2011 | 1996 Cadillac DeVille

1 Answer

Spark to distributor from coil, no spark coming from plug wires, replaced ignition module, no help


Hello Nummy.

If you have spark at the coil the module is OK. The module fires the coil.
Your problem then becomes the ignition wires, the distributor cap or the rotor.
These are the items that carry the high voltage to the spark plug.
There is also the possibility the spark is jumping off at the coil itself when all is hooked up.
This happens because the resistance increases through the wiring and jumping the gap at the spark plugs.
I hope your repair goes well. Thank you for using FixYa.

KL

Jan 15, 2011 | 1988 Chevrolet K1500

2 Answers

1995 mazda mx6 2.5 v6 kl engine. Replaced head gasket cam timing and enerything fine but when u start it the engine revs to 3000 rpm for about 5 seconds then comes down. then starts reving itself to about...


Hi,
Looks like vacuum leaks and some sensors are not connected.
Re check everything again and tell us what happen, so that we could guide you better.
Thanks for using Fixya!

Dec 08, 2010 | 1995 Mazda MX-6

1 Answer

Rattling noise coming from my 2005 mazda 6's engine. it only happens when i drive slowly such as going through kfc drive through


Good evening.
If this is a tinny type of rattle and it only happens at certain RPM's I would look for a loose heat shield over the exhaust pipes. Have someone apply the throttle until the rattles begins and listen under the car with a long screwdriver or a yardstick. Use the screwdriver to push on the various shields surrounding the manifold and pipes until the rattle stops. then use a hose clamp or two to tighten them up.
Also I see a lot of catalytic converters that become loose internally and rattle around inside it.
The only cure for that is to replace the converter.
If this rattle is an internal engine noise you should have an experienced mechanics ears give you an opinion.

Thank you for using FixYa.

KL

Nov 26, 2010 | 2005 Mazda 6

1 Answer

My subaru impreza (1993) sports wagon 1800cc,has a fault with the auto tranmission. when coming to a stop at traffic lights, when you go drive off it's like doing a hill start.... 2500 revs and the cars...


sounds like its not going back into first gear at the lights then it kicks back when you take off,but it takes off in second,get the adjustments looked at as you could damage it if you keep driving it,its cheaper to do a small fix than wait and have to do a major one,bite the bullet and get it looked at soon

Sep 14, 2009 | 1996 Subaru Impreza

1 Answer

2000 ml320 transfer case squeaky noise


hi,better to bring your car to gas station with car lifter,lift your car ,you can determine where the noise come from,or maybe you can see the rotation of your proffeler shaft,ty

Apr 05, 2009 | 2000 Mercedes-Benz M-Class

1 Answer

Chev Blazer


sounds like your transfer is going bad... get rid of it quick or it's going to cost you a lot of headaches and money
good-luck ray

Dec 18, 2008 | 1993 Chevrolet S-10 Blazer

1 Answer

Bmw z3 2.8 engine dies when cold


This used to happen to my car and it was the automatic choke not kicking in .....old cars had a pull out choke but inour days this is a thing of the past

Nov 03, 2008 | 2002 BMW Z3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...