Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Posted on Feb 23, 2010
For your 1994 Toyota Corolla 1.6L engine, you will need a BOSCH premium class Platinumir fusion spark plug. It is an Iridium platinum spark plug.
Its dimensions are a 14mm thread, a 19mm reach, and a 16 mm hex size.
I hope this will be of help to you.
Do remember to rate this answer.
Posted on Jun 30, 2010
There are 2 standard sizes for spark plugs, and you should use a "Spark Plug Wrench/ Socket"
Either the small version, which I believe is 5/8ths inches, or the large version, which is 3/4ths inches. Either one will cost a few dollars, but will help prevent you snapping the ceramic part of the plugs off.
There are other specialized sizes out there but they are specialized for specific uses. Not for cars in general.
The hardest part is removing the wire and boot without damaging the wire/plug connection. If you have compressed air, its a good idea to blow any accumulated crud out of the plug well, perhaps with the aid of a long brush, before removing it.
You need to pull straight up following the angle of the plug, BY THE BOOT - NOT THE WIRE. This can be difficult on old wires which are stuck to the plug. You can twist the boot rotationally to loosen it
Guide the socket over the exposed plug. Again, keeping a straight line on the plug and apply steady pressure counter clockwise to unscrew it. Once past the initial resistance you may be able to remove the handle and unscrew the rest of the way by socket (& extension) only.
To replace the plug (or new one) Set the plug into the socket. The foam liner will hold it in. Angle and move the plug in a straight line (same angle it came out) down towards the hole by the socket and extension without the handle, and - finger pressure only - carefully start the threads. I usually start by turning counter clock wise first to feel the threads seat squarely before trying to go clockwise. You should be able to wind the plugs down almost all the way in without force.
When you reach the bottom, attach the handle and snug up the pressure gently, then give it approx 1/4th or more additional turn to lock in. A little crud falling in the threads may require a little more help to wind it down, but never force it as the threads may be crossed. ( Then you ll have some fun)
Does this help?
Posted on Jun 30, 2011
Tips for a great answer:
May 14, 2015 | Cars & Trucks
Aug 08, 2014 | 2007 Jeep Compass 2.4
Jul 23, 2010 | 2003 Lexus ES 300
May 31, 2010 | 1996 Pontiac Firebird
Jul 07, 2009 | 2002 Kia Sportage
Jul 07, 2009 | 1992 Honda Accord
Apr 10, 2009 | 2003 Pontiac Sunfire
Mar 27, 2009 | 2003 Lexus ES 300
Jun 19, 2008 | 1998 Mercury Sable
16 people viewed this question
Usually answered in minutes!