Question about Cars & Trucks

Open Question

Trans shifts fine for about a hour then takes off in 2nd an will not go in to over drive ?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: no reverse sometimes geo metro a/t

The accelator cable is "Y" shaped. one side goes to the carb and the other to the tranmission. If you have the carb.side too tight it will give you the problem that you are having.
Robert

Posted on Jul 05, 2008

Ad
  • 88 Answers

SOURCE: 1994 nissan sentra shifting hard

change fluid in trans add lucas for trannys let me know if theres metal in the pan or if you have trouble tell fixya bout me ok

Posted on May 24, 2009

Molson02536
  • 3854 Answers

SOURCE: 4L60E Shifts fine in 1st, 2nd, & 3rd but will not shift into OD

The EMC detected and problem so it's in limp mode, As long as it's in limp mode the 4th and OD will not activate. Take care not to burn up the transmission by running it hard while your in the limp mode.
Your going to have to get the truck scanned to clear any codes and why there are DTC codes. Auto Zone scan for free and most auto shops charge $10.00 to $20.00 to scan sine they want the business.
If you want to clear the codes your self you can put the ignition to the run position and pull the ECM (Batt) fuse out for 20 sec and place it back in then start the truck. It may stall but let it, just start it again and this would have cleared all the DTC code history.
The transmission should be running fine unless there is a problem and the service engine light will be on again and you'll be in limp mode still with an updated DTC in the ECM.
Good luck and hope this helps.

Posted on May 26, 2009

  • 30 Answers

SOURCE: 1993 4l60e - Shifts hard on the 1-2 shift, works fine otherwise.

Did you change the transmission filter and gasket as well as the transmission oil before running your truck.

Posted on Sep 28, 2009

  • 1 Answer

SOURCE: P1722 CODE POPS UP TRANS WILL NOT SHIFT INTO 1st

Internal drum broken , remove trans and fix , can buy drum on eBay

Posted on Feb 16, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Transmission has to be manually shifted. Downshifts on its own, and i can take off in 1st but only at very slow speed. 2nd and 3rd gear seem fine other than manually shifting.


u need a scan using factory or vehicle specific gear--values of components will be diplayd so an xperiencd tech can decyfr--littl code readers dont du it---w age of car certain sensors etc need replacin-believe that trans is electric controled--dont rplace any parts til uve isolated issue----------also go to magicmechanic online and checout the napa library on that model

Mar 05, 2014 | 1995 Oldsmobile Cutlass Supreme

1 Answer

1993 chevy k1500 transmission problem


Do you mean start the car in drive? if so that problem is inhibitor switch. Other shift problems can be caused by TPS (throttle posistion sensor) if applicable

Oct 05, 2012 | 1993 Chevrolet K1500

1 Answer

01 Impala LTZ with 3.8 Trans won't shift out of


CHECK TRANSMISSION FLUID LEVEL FIRST BUT IT SOUND LIKE YOU NEED A FLUID AND FILTER CHANGE IF TRANSMISSION FILTER STOPPED UP TRANSMISSION PUMP CAN DRAW FLUID THROUGH CLOGGED FILTER.WHEN ENGINE AND TRANSMISSION GET HOT FLUID WILL GET HOT AND THIN ENOUGH TRAVEL THROUGH FILTER SO CAR CAN SHIFT INTO OVER DRIVE.DO A FLUID AND FILTER CHANGE SEE WHAT HAPPENS.

Aug 31, 2011 | 2000 Chevrolet Impala

1 Answer

1993 4l60e - Shifts hard on the 1-2 shift, works fine otherwise.


Did you change the transmission filter and gasket as well as the transmission oil before running your truck.

Sep 28, 2009 | 1994 Chevrolet C1500

1 Answer

Trans stuck in 2nd


Nope that's a hard failure of the trans. It's going into "limp in" mode. Take it to a shop & have the cvi's checked. You'll find it needs a trans.

Aug 03, 2009 | 1999 Dodge Ram

1 Answer

Slow Shifting Transmission When Cold


thats is normal for almost all the toyota's
the trans has to get to operating temp before it starts to shift normal.

Jun 25, 2009 | 1997 Lexus ES 300

1 Answer

1994 nissan sentra shifting hard


change fluid in trans add lucas for trannys let me know if theres metal in the pan or if you have trouble tell fixya bout me ok

May 24, 2009 | 1994 Nissan Sentra 4-Door

1 Answer

88 toyota supra auto trans slips. won't up shift to 2nd gear


yep, sounds like your transmissions on its last leg, mabye you can get by, by starting in 2nd, if you have the option lol, but auto tran's are pretty cheap on ebay or try www.supraforums.com seen one for 300$

Apr 02, 2009 | 1988 Toyota Supra

1 Answer

Jumps into manual 2nd gear


When was last fluid & filter change?

Nov 22, 2008 | 2000 Dodge Stratus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...