Question about Volkswagen Golf

Open Question

I have a golf 1 1.6 automatic it goes into 1st and 2nd gear but not 3rd and 4th what can the problem be

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
junkman1249
  • 552 Answers

SOURCE: 2001 Jetta Manual Transmission misses 2nd gear

throw out bearing

Posted on Dec 05, 2008

Ad
raycrazek
  • 106 Answers

SOURCE: 96 plymouth voyager no shift

you say the fluid looks good... that's great.
now next time your out drive for about ten good minuetes long enough for the transmission to get nice and warm and then pull over to nice level ground and with the vehicle in park check the fluid again. it's kind of hard to read because it always has a lot of bubbles on it and stuff. but it may be low on fluid.. good-luck ray

Posted on Jan 16, 2009

  • 1 Answer

SOURCE: I only have 3rd and 4th gear, 1st 2nd and 5th are

Purchase a gear shift repair kit for your car. They are pretty cheap. About 20 bucs. The ball and bushings are probably worn.

Posted on May 31, 2009

  • 2 Answers

SOURCE: automatic transmission not shifting into 3rd or 4th

my 1999 f250 super duty will not shift into overdrive

Posted on Aug 13, 2009

SOURCE: The transmission is hanging up in 2nd gear and not

The absence of 3rd and 4th is imposed by the transmission computer as a precautionary measure. The system has detected fault and rather than risk doing any greater damage has provided a limp home service. It needs to have a transmission specialist look it over and read the error codes. How do your transmission fluid levels look?

Posted on May 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The Pacifica will not shift past 4th gear. It shifts normally through 1st, 2nd, 3rd, and 4th gear. Their is no high reeving RPS, no clunking, no lurching. It will just not shift past 4th gear.


is there an OD button that might have been pressed .if it has lots of miles on it it could be needing a flush job . last one I got done was around 100.00 at jiffy lube.

Nov 12, 2015 | 2005 Chrysler Pacifica

1 Answer

2003 Grand Am Automatic will shift normal from 1-2 but will not shift into 3 or 4.


Worn clutches or solenoid issues if it is an Alison style box.

Apr 02, 2017 | Pontiac Cars & Trucks

1 Answer

2001 chevy s10 automatic 150,000 miles suddenly lost 3rd and 4th gears


USE A SCANNER TO CONFIRM WHETHER HAS ANY SOLENOIDS HAD TO DO WITH.

Aug 29, 2012 | 2001 Chevrolet S-10

2 Answers

Ford transmission wines in 1st 2nd 3rd revers, no


It is a 5 speed manual transmission? If it is noisey in all gears except for 4th, then the problem is countershaft bearings.

Apr 16, 2010 | 1995 Ford Aerostar

1 Answer

What is the function of 1st,2nd,3rd,4th,5th gear?


the function of the gears are to transfer and convert energy created by the engine into momentum

Feb 12, 2010 | 2003 Toyota Corolla

1 Answer

Only runs in 1st and 2nd gear and reverse.


This is a fault mode in which the transmission either loses electrical power or the PCM deactivates all of the electronics. The transmission will default to max line pressure. The driver will have Reverse and 3rd, with manual 2nd available by putting the gearshift in 2 or 1 (doesn't matter). 1st, 4th, and TCC lockup will not be available. It will not hurt the car to drive it like this for short periods, but use manual 2nd to get the car moving, and be aware that the trans will generate more heat than normal while operating in limp-home mode due to increased torque converter slippage during 2nd gear starts and no lockup in 3rd gear.

Trans shifts into gear harshly, car feels sluggish off the line
, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmission is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the under hood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.

No 1st or 4th available; trans shifts 2nd to 3rd by itself in D or OD and locks the converter : ShiftA solenoid failed. Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.

Car goes into gear but feels very sluggish like the brakes are dragging, but it will roll easily (starts out in 4th gear), you manually shift to 2 to get it moving, once it's moving you put it back in OD and the car shifts 3rd to 4th on its own and locks the converter at the appropriate time: ShiftB solenoid failed: Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.

Dec 14, 2009 | 2006 Hummer H3

1 Answer

What different gear box can fit honda integra xsi vtec 1600cc b16a? i want to change my gear box ,and i want to know what exactly other gear box can fit my car?thanks its a integra bot the product can show...


J1/S1 Found in: Integra XSI/RSI (DA6) Type: Cable 1st: 3.230 2nd: 2.105 3rd: 1.458 4th: 1.107 5th: 0.848 R: 3.000 FD: 4.400 Y1 Found in: CRX/Civic (optional LSD) Type: Cable 1st: 3.166 2nd: 2.052 3rd: 1.416 4th: 1.103 5th: 0.870 R: 3.000 FD: 4.266 YS1 Found in: Integra 92-93 XSI/RSI (DA6, DA9) Type: Cable 1st: 3.307 2nd: 2.105 3rd: 1.458 4th: 1.107 5th: 0.880 R: 3.000 FD: 4.400 S80 Found in: Integra Type R 98+ (LSD) Type: Hydraulic 1st: 3.230 2nd: 2.105 3rd: 1.458 4th: 1.034 5th: 0.787 R: 3.000 FD: 4.785 S80/Y80 Found in: JDM SiR-G (optional LSD) Type: Hydraulic 1st: 3.230 2nd: 1.900 3rd: 1.360 4th: 1.034 5th: 0.787 R: 3.000 FD: 4.400 Y21/Y80/S80/S4C Found in: JDM 96-97 Integra R(LSD) JDM Civic R [EK9](LSD) JDM Civic SiR [EK4, EG6] JDM CR-X DEL SOL SIR (EG2)(optional LSD) USDM DEL SOL VTEC (EG2)(OPTIONAL LSD) Type: Hydraulic 1st: 3.230 2nd: 2.105 3rd: 1.458 4th: 1.107 5th: 0.848 R: 3.000 FD: 4.400

Jun 08, 2009 | 1990 Honda CRX

1 Answer

Transmission won't shift to 2nd and 3rd gears goes from 1st to 4th.


Doesn't sound like a simple fix. I would suggest having it serviced.

May 05, 2009 | BMW 318 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76132 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...