Question about Suzuki Cars & Trucks

Open Question

In which year did Suzuki Jimny change the rear body light size?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: suzuki jimny 1.3 2004

Either a short in wiring; a fuse is needing replacing or the engine is not running properly, which will cause the light to come on.

Posted on Mar 25, 2009

Ad
ourhowse
  • 2007 Answers

SOURCE: I NEED TO CHANGE FUEL FILTER ON SUZUKI JIMNY

should be a silver canister under the truck, probably bolted to the frame. I can't tell from your post what you're working on. Looks like Suzuki jimmy? What ever. it should be under it.

Posted on May 19, 2009

  • 6 Answers

SOURCE: What does eml warning light on a Suzuki Jimny mean?

That is the engine managent light, there is a possible engine sensor fault it will have to be put on a computer. you should be able to have that done at any garage that has the equipment. lot cheaper than main dealer.

Posted on Mar 22, 2012

emissionwiz
  • 76846 Answers

SOURCE: I have a suzuki jimny 2002 and get check engine light on and code P1600 an P0763 and when the switch is on i hear the relay on the TCM. can you suggest?

P0763 - Shift Solenoid C Electrical
Possible causes- Faulty shift solenoid C valve
- Shift solenoid C valve harness or connectors
- Shift solenoid C valve circuit is open or shorted
- Low transmission fluid level
- Dirty transmission fluid
When is the code detected?The P0763 code is detected when the gear required by the ECM does not match the actual gear when vehicle is driven.Symptoms- Engine Light ON (or Service Engine Soon Warning Light)
- Transmission will not shift gears.P0763 Description Shift solenoid valve C is turned ON or OFF by the Transmission Control Module (TCM) in response to signals sent from the park/neutral position (PNP) switch, vehicle speed and Engine Control Module (ECM) (throttle opening). Gears will then be shifted to the optimum position.

P1600 - Loss of KAM (Keep Alive ECM memory) Power; Open Circuit

Check all fuses related to the ECM

Posted on Jun 22, 2012

emissionwiz
  • 76846 Answers

SOURCE: fuel pressure suzuki jimny

It should be about 45 PSI at idle.

Posted on Oct 02, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is error code 33920-76JB2 on Suzuki Jimny


no year year, no joy
this is uSa forum not one JIMNY here, zero , nada, parts or books.
that is not an error code!
the ECU has 33920-76Jb2 part number on sticker side
33920 means ECU in Suzuki PARLANCE.
post a problem
and scan it

Mar 17, 2017 | Suzuki Cars & Trucks

1 Answer

What is the emission control system on a suzuki jimny? my emission control light came on and the jeep wont start..how could this be solved?


sorry nat, its no jeep.. (closest match here is Samurai)
moved yah i did.
No year stated, hopeless, for sure.. that...
nor is Jimny sold in USA, and this is a uSA forum.
Means we have no books on Jimny here...for that fact.
forget that lamp CEL?, it glows telling you , PCM has power and as a self test on lamp on all cars.
but the IMMO lamp? that be #1 to see... if fitted. as some are.

what matters only is this.. see how far you can get.?
won't start means nothing unless you say it cranks and don;t start.
starter motor sounds ok, not silent.?
see, we can hear this or guess. and is KEY to the reasons.

all you can do is test fuse.
see if cluster immoblizer light is glowing funny or flashing wrong.

dont crank ,? clean battery lugs, and then charge battery
jumper cable crank it.
cranks ok, check for spark.
if dont know how get tow to shop that does.

Mar 27, 2016 | Suzuki Jimny Cars & Trucks

1 Answer

Jimny suzuki not engaging, seems neutral always. What seems to be the problem?


welcome to usa forum, we dont have Jimny here.
but car is kind simular to a vitara.
no year stated, so that makes real accurate answers impossible.
no transmission stated. or engine size

is it a stick or auto trans?
is car 2wd or 4wd?

is the lever stuck in nutural.?
or is the lever working right but the transmission fails in all gears and reverse.
mine has stick and 5 speeds, and reverse so has 6 gears to try.
If an automatic? trans. check the levels. per the operators guide do not guess.
and change its filter, if never done.
if automatic, make sure the lever moves its cable and the other end of cable is still attached to the trans lever. on the box.
they both move same amount, (cable drive does that)
if not the cable is bad, or bits there.

Jun 23, 2015 | Suzuki Cars & Trucks

1 Answer

Stuck in 4 wheel drove low


nice double post. read the last one, its was answered 100%
for all cases.
its not AWD is it?

you changed years from 05 to 10, so is it a 10?
and is it AWD.
got this knob?

http://www.fixkick.com/tranny/xfr-case/4wd%20windup/suzuki-grand-vitara-4mode-4wd-selector-switch.jpg

Mar 28, 2015 | 2010 Suzuki Jimny 1.3

1 Answer

Suzuki K6a engine. Turns over but won't start


we dont have this engine in USA< (this forum is USA forum.....)
what year, what car? ?? what country?
the k6a fits many cars, and many years and can be carb or EFI fueled.

the K6a line up, do tell what you are driving....please.
now to answer in GENERIC Mr. Otto Cycle mode. (gas engines)
no spark, check spark.
never tuned up, ever.
low compression, find timing chain slipped or worse.
twin cam 3 cylinder.
with chain drive. if chain is/was quiet, the cam timing should be good. as is compression over 150psi.
if compression is good, and spark good, x3
then it will run on test fuel, does it?
of not clogged melted CAT?

Mar 10, 2015 | Suzuki Cars & Trucks

1 Answer

Location power steering reservoir


year car, lots of suzuki's made, and lots of bodies, is it a jimny?
neither sated.

Dec 28, 2013 | Suzuki Cars & Trucks

2 Answers

My Suzuki jimny will not go into four wheel drive, the four wheel drive light is on on the dash,it is a 2004 thanks.


Will the leaver not move? Try reversing a little, the forward. This might let it slip in place. Sometimes you get transmission wind up, causing the 4wd drive not to enguage.
If it won't come back out try the forward and reverse thing again.
I don't understand the light being on and your still not getting 4WD!

Dec 13, 2010 | Suzuki Sidekick Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...